Owners manual for the OSD Audio SMP200 Class D subwoofer amplifier, covering front and rear panel controls, installation, ventilation and connections.
The OSD Audio SMP200 is a Class D 200 Watt subwoofer amplifier intended to drive passive subwoofers in home theater systems. It offers a stereo/mono line level audio input (RCA), a stereo speaker level input, an LFE input from a suitably featured device, front-panel phase, crossover and volume controls, auto-sensing power on/off, and a 12-24 VDC trigger input.
The owners manual describes the front and rear panel features, shelf mounting and ventilation requirements, and the connection setups: line level input configuration from an amplifier, receiver or preamp, and speaker level input from a multi-room distribution amplifier. It also covers subwoofer wiring, the trigger connection and AC mains connection.
| Amplifier class and power | Class D, 200 Watt |
|---|---|
| Speaker Level OUT power rating | 100 Watts RMS, 200 Watts MAX |
| Sub OUT maximum output power | 120 W at 8 ohms; 200 W at 4 ohms |
| Crossover range | 35 Hz to 160 Hz |
| Phase range | 0 to 180 degrees |
| Trigger input range | +12 to +24 VDC, tip positive, sleeve ground |
| AC input | 115V/230V, 60/50Hz, 250W |
| Auto power off delay | 15 minutes with no audio signal |
One AC power cord and one user guide are included.
It is audio-sensing, so it turns on when an audio signal reaches the line or speaker level inputs, and turns off after 15 minutes with no signal.
A passive (non-amplified) subwoofer, connected to its + and - terminals.
The crossover sets the frequency at which audio content passes to the subwoofer, adjustable from 35 Hz to 160 Hz.