NI Automated Test Instruments Selection Guide

A guide for selecting appropriate analog, RF, and digital instruments for automated test systems based on signal direction, frequency, bandwidth, and other…


NI Automated Test Instruments Selection Guide - cover page
Brand
NI
Category
Other Electronics
Document type
Product Leaflet
Language
English
Pages
17
File format
PDF
File size
2.6 MB
Published
25 October, 2026
Updated
25 October, 2026
MD5 checksum
FBD5154926B9B0316A505DD2C90213CB

About this manual

This document provides guidance on selecting the correct measurement instruments for building automated test systems. It emphasizes that choosing the right tool is critical to avoid wasting time and affecting quality, covering common instruments like DMMs and oscilloscopes as well as newer categories such as vector signal transceivers.

The guide details key considerations for instrument selection, including physical limitations of noise and bandwidth in analog and RF instruments. It outlines specific questions engineers must answer regarding the Device Under Test (DUT), such as signal direction (input/output) and frequency range, to determine the appropriate instrument category.

What's inside

  • Introduction
  • Analog and RF Instruments
  • Key Specifications for Selection
  • Signal Direction and Frequency
  • Resolution vs. Sampling Rate
  • Digital Instruments
  • Parallel vs. Serial Standards

Frequently asked questions

What are the key questions to determine which type of instrument to start researching?

Engineers must first consider two critical questions: what is the direction of the signal (input, output, or both) and what is the frequency of the signal (DC, kHz, MHz, or GHz).

What is the acceptable value for the Test Accuracy Ratio (TAR)?

The acceptable value for TAR depends on the test performed and required certainty, but a value of 4 or higher is generally considered acceptable.

What is the recommended ratio between an oscilloscope's sampling rate and input signal bandwidth?

To accurately digitize an input signal, the real-time sampling rate of a digitizer should be at least 10 times the input signal bandwidth.

Download PDF (2.6 MB)

More NI Manuals


View all NI manuals →