Nautilus Integration FlexMod P3 Laser Diode Driver User Manual

User manual for the Nautilus Integration FlexMod P3, a linear current-regulated laser diode driver delivering 100mA to 4A with DC-160kHz modulation bandwidth.


Nautilus Integration FlexMod P3 Laser Diode Driver User Manual - cover page
Brand
Nautilus Integration
Category
Other Electronics
Document type
User Manual
Language
English
Pages
3
File format
PDF
File size
171 KB
Published
17 November, 2026
Updated
17 November, 2026
MD5 checksum
566450261E13482CB5952A17CBB976EB

About this manual

The FlexMod P3 from Nautilus Integration is a high-speed, high-current linear current-regulated diode driver in a very small footprint. It is designed for flexible industrial, experimental, and custom optical applications, and can also drive current-regulated loads such as high-power LEDs and small current-controlled heating and cooling devices. The driver operates from 100mA to 4A with a modulation bandwidth of DC-160kHz and no overshoot.

The manual covers the driver's operation as a voltage-to-current converter with diode protection and safety features, including interlock loop sensing, output loop circuit sensing, ESD protection, and a 7-second soft-start delay. It provides step-by-step setup and operation instructions covering preliminary setup, bias and gain current adjustment, final load connection, optional balance adjustment, startup delay disable, standby LED beam suppression, fuse replacement, and live current measurement.

What's inside

  • Description of Operation
  • Setup and operation
  • Current Adjustment
  • Final Connection
  • Balance Adjustment
  • Startup Delay Disable
  • Standby LED Beam Suppression
  • Fuse
  • Live Current Measurement

Specifications

Input Voltage (Vdd)5 - 24 V
Max Output (Diode) VoltageVdd - 1.5 V
Output Current0.01 - 4.0 A
Bias Current0 - 1000 mA
Regulation Ripple (1Hz - 100kHz)< 1.0 %
Input Impedance99 kΩ
Maximum diode lead loop length3 ft
Maximum continuous power dissipation25 W
Dimensions1.25" x 0.87" (32 x 22 mm)
Modulation bandwidthDC - 160 kHz

Frequently asked questions

How do I disable the 7-second soft-start delay on the FlexMod P3?

Solder a bridge across the two rightmost pads of the group of five pads underneath the large cylindrical black resistor on top of the board.

What fuse does the FlexMod P3 use and where can I get a replacement?

The FM P3.3 is equipped with a 5A protection fuse; replacement fuses are available from Digikey, part #MFU08055.00CT-ND.

How can I measure the output current while the driver is active?

Clip leads from each side of the large black cylindrical resistor on top to a multimeter set to measure volts or millivolts; the current output is 1 Amp per 200 milliVolts.

When is a heat sink required for the FlexMod P3?

Attach the transistor to a heat-sink for modulation currents over 250mA or power supplies over 5.5V; the included heatsink is adequate for currents up to 500mA with a 5V supply.

Download PDF (171 KB)