MTD MTD12.5-M/K-06-W / M/K-06-B Desk Lamp User Manual

User manual for the MTD MTD12.5-M/K-06-W / M/K-06-B desk lamp: head adjustment, 6-step dimming, reading/writing modes, rest timer and delay off.


MTD MTD12.5-M/K-06-W / M/K-06-B Desk Lamp User Manual - cover page
Brand
MTD
Category
lighting
Document type
User Manual
Language
Chinese
Pages
1
File format
PDF
File size
1.6 MB
Published
17 November, 2026
Updated
17 November, 2026
MD5 checksum
2AB728EC4B672B0B1579EC1514BF915A

About this manual

This is the Chinese user manual sheet for the MTD12.5-M/K-06-W / M/K-06-B desk lamp. It explains how the lamp head may be adjusted and warns that the lamp head should not be tilted down more than about 40 degrees because of the risk of tipping over, and that the table surface used should not be tilted more than 6 degrees. The normal working position is described with the light aperture 400 mm above the working surface.

The manual covers the touch controls: an on/off key (touch to switch on, long press 0.5 s to switch off, with soft start/soft off and power-off memory), a dimming strip with 6 brightness steps, a mode key for switching between reading and writing modes, a rest timer that reminds the user after 45 minutes, and a delay-off function that turns the lamp off after 1 minute. It also states that the light source cannot be replaced and that the whole lamp must be replaced when the light source reaches the end of its life. This manual is written in Chinese.

What's inside

  • Lamp head angle rules
  • Adjusting the lamp head
  • Adjustment for reading and writing work
  • Dimming strip (6 steps)
  • Mode switch key (reading / writing)
  • On/off key
  • Rest timer (45 minutes)
  • Delay off (1 minute)
  • Warning: non-replaceable light source

Specifications

Product weightLess than 1 kg
Lamp head downward adjustmentAbout 90°
Lamp head up/down adjustmentAbout 120°
Lamp head left/right rotationAbout 90°
Maximum table surface tiltNot more than 6°
Light aperture height above working surface400 mm
Illuminance at maximum brightness levelAA grade
Dimming levels6 steps
Delay-off time1 minute

Frequently asked questions

How long does the rest timer run before reminding me?

About 45 minutes after the timer is started, the main light pulses twice to remind you to take a break and the timer function then exits.

What happens if I tilt the lamp head down too far?

Tilting the head down more than about 40 degrees carries a risk of the lamp tipping over.

How do I switch the lamp on and off?

Touch the on/off key briefly to switch on, and long press it for 0.5 s to switch off.

Can I replace the light source of this lamp?

No. The light source is not replaceable; when it reaches the end of its life the whole lamp should be replaced.

Download PDF (1.6 MB)

More MTD Manuals


View all MTD manuals →