The Monitor Audio Bronze W10 subwoofer owner's manual covers unpacking, rear-panel controls, positioning and setup, specifications and troubleshooting.
This is the owner's manual for the Monitor Audio Bronze W10, an active subwoofer in the Bronze Series. It explains unpacking, the rear amp panel and controls, positioning and initial setup, system setup, specifications and troubleshooting.
The rear panel includes RCA stereo and LFE inputs, a 12 volt trigger input, crossover, volume, bass and phase controls, an On/Auto power mode switch, mains power switch, fuse and voltage selector. The document lists the subwoofer's specifications and owner information.
| System Format | Active sub-woofer system – Auxiliary Bass Radiator (ABR) loading |
|---|---|
| Low Frequency Limit | 34Hz (-6dB) |
| Upper Frequency Limit | Variable 50 – 120 Hz @ 24dB/Octave |
| Amplifier Power Output | 220W @ < 1% THD+N |
| Amplifier Classification | Class D amplifier with Switch mode power supply (SMPSU) |
| Bass EQ Switch | Music/ Movie/ Impact |
| Phase Control | 0 & 180 degrees |
| Driver Complement | 1 x 10” (250mm) C-CAM® long throw driver; 1 x 10” (250mm) Auxiliary bass radiator |
| Input Impedance | > 20K Ohms |
| Mains Input Voltage | AC 110 - 120 V ~ 50/60Hz; AC 220 - 240 V ~ 50/60Hz (Switchable, Factory Region Preset) |
| Dimensions (H x W x D), including amp & feet | 364 x 320 x 364mm (14 5/16 x 12 5/8 x 14 5/16 Inch) |
| Weight (unpacked) | 12.8Kg (28lb 2oz) |
| Connections | Stereo RCA in, LFE in, 12v Trigger in (3.5mm mono mini-jack) |
| Power Consumption | Standby: < 0.5W (ErP approved); Typical Idle: < 10W; Max Rated: 200W |
The Bronze W10 has a low frequency limit of 34Hz (-6dB).
The Bass switch has three settings: Music, Movies and Impact.
It provides external power control from an AV amplifier or receiver to the Bronze W10, turning it on from standby.
It remains on for about 15 minutes without an input signal before entering standby.