MODSTER Vector 802 Remote-Controlled Boat Operating Instructions

Operating instructions for the MODSTER Vector 802 remote-controlled boat, covering safety warnings, battery charging, rudder installation and transmitter…


MODSTER Vector 802 Remote-Controlled Boat Operating Instructions - cover page
Brand
MODSTER
Category
Other products
Document type
User Manual
Language
German
Pages
24
File format
PDF
File size
2.9 MB
Published
17 November, 2026
Updated
17 November, 2026
MD5 checksum
94431CB57988A3C6610F636521EC2215

About this manual

The MODSTER Vector 802 is a remote-controlled boat model supplied with a transmitter, connecting plug, hex screwdriver and display holder. The manual explains that remote-controlled boat models are not toys, that the product is suitable for children under 14 only with adult supervision, and that users should check the transmitter and model for visible damage before use.

It covers the included safety warnings, charging the drive battery with the balance charger and power supply, securing the battery in the boat, installing the rudder, binding the transmitter to the receiver, and basic throttle and steering control. It also lists warnings for charging and for operating the boat on water. This manual is written in German.

What's inside

  • Introduction
  • Warnings and Safety Instructions
  • Before Starting
  • Package Contents
  • Battery & Charger
  • Charging Procedure
  • Transmitter
  • Rudder Installation
  • Binding Transmitter and Receiver
  • Battery Installation in the Boat

Specifications

Charging time with included power supply1.5 to 2.5 hours
Battery typeLiPo
Charge end voltage4.2 V per cell
Recommended first charge rate0.3–0.5 C
Transmitter battery4 x AA batteries (not included)
Full charge time at 1Capprox. 90 minutes

Frequently asked questions

How long does it take to charge the drive battery with the included power supply?

The manual states that charging normally takes between 1.5 and 2.5 hours for a fully or nearly fully discharged battery.

What batteries are required for the transmitter?

The transmitter uses four AA batteries, which are not included in the scope of delivery.

How do I bind the transmitter to the receiver?

Switch on the receiver, then switch on the transmitter within 5 seconds; binding is successful when the receiver LED stops blinking.

What should I do if the battery becomes hot or changes shape during charging?

The manual says to end the charging process if the battery feels hot or changes shape.

Download PDF (2.9 MB)

More MODSTER Manuals


View all MODSTER manuals →