MINUTEMAN Office Plus Series UPS Owner's Manual

Owner's manual for the MINUTEMAN Office Plus Series UPS covering controls, installation, operation, troubleshooting, battery replacement, specs and warranty.


MINUTEMAN Office Plus Series UPS Owner's Manual - cover page
Brand
Minuteman
Category
Other Electronics
Document type
User Manual
Language
English
Pages
18
File format
PDF
File size
391 KB
Published
10 November, 2026
Updated
10 November, 2026
MD5 checksum
19B0D8D5EE439C19219D274AE69505C3

About this manual

This is the Owner's Manual for the MINUTEMAN Office Plus Series UPS (uninterruptible power supply), copyright Para Systems, Inc., 2000. It explains the front-panel LEDs and switches, placement and connection of equipment, optional telephone/network and video coax surge protection connections, and the optional 9-pin computer interface port for MINUTEMAN Power Management software.

The manual also includes safety instructions, receiving inspection guidance, a Para Systems life support policy, troubleshooting, battery replacement, obtaining service, specifications, configurable parameters, a limited product warranty and a Declaration of Conformity. It states that the UPS must be connected to a two pole, three wire grounded receptacle and that batteries should be charged a minimum of 4 hours before use.

What's inside

  • Introduction
  • Controls and Indicators
  • Installation
  • Operation
  • Troubleshooting
  • Replacing the Battery
  • Obtaining Service
  • Specifications
  • Configurable Parameters & Settings
  • Limited Product Warranty

Specifications

Communication portStandard DB9 female with RS232 communications
Input power connectorNEMA 5-15P
Signal protection connectorsRJ-45/RJ-11 modular connectors for 10 Base-T network / single line telephone; coax connectors for video surge protection

Frequently asked questions

How long should the UPS battery be charged before first use?

It is recommended that the batteries be charged for a minimum of 4 hours before use; the UPS may be used immediately, but run time on battery may be shorter than expected.

Do I have to connect the telephone/network or video coax surge protection?

No. These connections are optional and the UPS works properly without them.

What does the Check Battery LED mean?

It lights up when the UPS has detected that the battery is weak or bad, and battery replacement might be required.

Can I plug a laser printer into the battery backup outlets?

Not unless the UPS is rated 2000VA or greater, because a laser printer draws significantly more power when printing than at idle and may overload the UPS.

Download PDF (391 KB)

More Minuteman Manuals


View all Minuteman manuals →