MediaTek guide to MT7620A TFBGA Wi-Fi SoC PCB layout: placement, layer stack, power topology, RF matching network, DDR2, PCI-e and RGMII notes.
The MT7620A TFBGA PCB Layout Guide is a MediaTek presentation slide set (marked Confidential, V0.2) giving layout design comments for boards built around the MT7620A 11n 2X2 Wi-Fi SoC in a TFBGA package. Page footers carry a 2012/10/16 date and a MediaTek copyright line, and the deck is written for hardware developers doing board design rather than for end users.
The contents list covers placement, a 4-layer AP PCB layer stack, the system block diagram, power topology, the RF matching network, DDR2, PCI-e, Ethernet, RGMII and an Others section. The placement comments put the switching regulator and PMU circuit on the lower right side of the MT7620A, the Ethernet port on the lower left, DDR2 on the left and the RF circuit on top, and ask for the crystal to be close to the chip with a ground plane around its clock trace, at least 20 mil from other traces.
| Package | TFBGA |
|---|---|
| Wi-Fi capability | 11n 2X2 |
| Ethernet configuration | 4FE+2GbE (or 5FE+1GbE) |
| Crystal | 20 MHz crystal (Xtal) |
| Xtal clock trace spacing | At least 20 mil from other traces |
| Power rails shown | 3.3 V to 1.8 V LDO; 3.3 V to 1.25 V LDO switching regulator |
| Memory shown in block diagram | SPI flash 32 Mb and DDR2 |
They should be on the lower right side of the MT7620A.
The RF circuit should be on the top of the MT7620A.
It should have a ground plane around it and be kept at least 20 mil from other traces.
The Ethernet port should be on the lower left side of the MT7620A.