Installation guide for the Magnaflux CMD3-2060 Magnetic Particle Inspection Machine, covering setup, power, grounding, and fuse requirements.
This guide provides step-by-step instructions for installing the Magnaflux CMD3-2060 Magnetic Particle Inspection Machine. It covers space requirements, floor conditions, power connection, grounding, and fuse specifications. The document also references local electrical codes and includes a table of electrical input specifications for different voltage and phase configurations.
The manual is shipped electronically and includes detailed assembly instructions for the enclosure. It advises contacting Magnaflux Customer Service or an authorized service center for questions.
| Input Voltage | 208V, 230V, 380V, 415V, 460V, 575V |
|---|---|
| Recommended Line Fuse (Amps) | N/A, 225, 225, 200, 200 |
| Recommended Wire Size (AWG) | N/A, N/A, 3/0, 3/0, 2/0, 2/0 |
A minimum of two feet is required at both ends and the rear of the inspection unit to ensure adequate space for servicing and ventilation.
Connect the incoming power to the Incoming Power Connection located inside the unit on the back side. Attach the Chassis Ground wire to the inside of the unit to the Chassis Ground Connection Screw.
Recommended fuse sizes vary by voltage: 225A for 380V and 415V, 200A for 460V and 575V.