Linx V6.0.80 Dual-Node Multipath and Hot-Standby Deployment Guide

About this manual

This document serves as a deployment guide for the Linx V6.0.80 system, specifically detailing the installation and configuration of the Multipath Software and the Dual-Node Hot-Standby Software. It is designed for internal personnel to correctly implement these solutions on Linx security operating systems.

The guide covers preparation steps including software version confirmation and storage mode verification (Active/Passive, Dual-Active, or Dual-Controller). It provides step-by-step instructions for installing the software packages, configuring sequence numbers, setting up storage modes, and verifying basic functions such as device mapping and fiber plugging/unplugging tests. Additionally, it includes procedures for hot-standby environment setup, Corosync and Pacemaker configuration, and troubleshooting common issues. This manual is written in Chinese.

What's inside

• Overview
• Preparation
• Linx Multipath Software Installation
• Multipath Configuration
• Linx Hot-Standby Software Installation
• Hot-Standby Environment Setup
• Verification of Functions
• Common Issues Resolution

Frequently asked questions

What operating system version is required for this guide?

This guide is only applicable to the Linx V6.0.80 version of the operating system.

What network interface requirements are needed for the dual-node setup?

The machines must have at least four network ports, and at least two heartbeat cables are required.

What is the default storage configuration template if the storage mode is unknown?

If the storage vendor cannot confirm the mode, the default dual-controller configuration template should be selected.