LIGO T0900579-v1 Diagnostic Breadboard Computer Control Manual

LIGO manual for Diagnostic Breadboard computer control: field box cabling and channels, real-time code model, configuration, calibration and measurements.


LIGO T0900579-v1 Diagnostic Breadboard Computer Control Manual - cover page
Brand
LiGo
Category
Other
Document type
User Manual
Language
English
Pages
51
File format
PDF
File size
1017 KB
Published
16 November, 2026
Updated
16 November, 2026
MD5 checksum
5D955BA1FDF2AB3095516DBA8C4B14CA

About this manual

This manual describes how to perform diagnostic laser beam measurements with the computer control of the Diagnostic Breadboard (DBB). It covers the field box that connects the DBB with the A/D and D/A cards, the Simulink model used for real time code generation, and the MEDM screens, and it gives instructions for calibrating the field box and the A/D and D/A cards and for performing the laser beam measurements.

The document starts with definitions and acronyms and then describes the field box, its cabling, channel assignment and whitening/de-whitening filters. Later sections cover the real time code model and its subsystems, the control screen, the various configuration items (scanning, TPD and RPD photodiodes, prealignment, demodulation phase, PMC length control, auto alignment and interlock), calibration of photodiodes, PZT and error signals, and measurements of relative power noise, frequency noise, pointing noise, beam quality and data acquisition.

What's inside

  • Introduction and definitions/acronyms
  • Field box
  • Cabling
  • Channel assignment
  • Whitening and de-whitening filter
  • Real time code model
  • Control screen
  • Configuration
  • Calibration
  • Measurements

Specifications

A/D and D/A channels required for control24 A/D and 16 D/A channels
Minimum A/D card channelsAt least 24
Minimum D/A card channelsAt least 16
Auxiliary inputs3 inputs, approx. -10 V to 10 V
Supported multiplexing shuttersTwo shutters (Thorlabs SH05)

Frequently asked questions

What is the field box?

It is an electronic module placed in the electronic crate of the DBB and is the connection between the electronic signals of the DBB and the computer control system.

How many A/D and D/A channels are needed to control the DBB?

24 A/D channels and 16 D/A channels are necessary.

What position must the field box PCB switches be in when Controller 1 and Controller 2 are present?

The switches have to be in the 'ADD' position when the two control modules are in the crate.

What happens if the control modules and the field box are operated at the same time?

They must never be operated at the same time, because the modules will try to drive the same lines on the crate bus.

Download PDF (1017 KB)