Lexus CT200H 2012 Door Edge Guard Installation Instructions

Installation instructions for the Lexus CT200H 2012 door edge guard accessory kit, part numbers PT936-76110-XX and PT936-76120-XX.


Lexus CT200H 2012 Door Edge Guard Installation Instructions - cover page
Brand
Lexus
Category
Vehicle Accessories
Document type
Installation Guide
Language
English
Pages
9
File format
PDF
File size
252 KB
Published
16 November, 2026
Updated
16 November, 2026
MD5 checksum
25354B65AAAA5208C543673F7F1FEDED

About this manual

This document is the installation instructions for the Toyota/Lexus CT200H 2012 door edge guard (DEG) accessory, issued 9/29/2011 under part numbers PT936-76110-XX and PT936-76120-XX. The kit contains four door guards: front driver, front passenger, rear driver and rear passenger door guards.

The 9-page procedure covers cleaning the door trailing edge, fitting paper or magnetic templates around the door handle, tapping the compression-fit channel onto the door edge with a rubber mallet, checking that all four doors open and close without interference, and a final installation checklist. It also describes removal with a Nylon Removal Tool and notes that a removed DEG should be replaced with a new part.

What's inside

  • Kit Contents
  • Hardware Bag Contents
  • Additional Items Required For Installation
  • Recommended Tools
  • Installation of Door Edge Guard (DEG)
  • DEG Removal
  • Checklist
  • Mounting Templates

Specifications

Part numberPT936-76110-XX, PT936-76120-XX
Kit contents4 door guards (front and rear, driver and passenger)
IssueA, 9/29/2011
Retention designCompression fit

Frequently asked questions

Can a door edge guard be removed and reinstalled?

No. The DEG uses a compression fit design, so retention cannot be assured if it is reinstalled; a removed guard should be replaced with a new part, using a Nylon Removal Tool for removal.

What tools are needed to install the door edge guards?

A 12-oz. rubber mallet, a Nylon Removal Tool (SST p/n 00002-06002-01), plus distilled water in a spray bottle, a lint-free towel, blue painter's masking tape and scissors.

How do I confirm the door edge guard is fully seated?

After tapping the channel along the full length of the door, lightly tap with the firmer side of the mallet; a solid report confirms the DEG is fully seated, otherwise repeat the seating steps.

How should the door edge be cleaned before installation?

Clean and dry the trailing edge of the door with distilled water and a lint-free towel; at Port, clean first with TMS approved U22937 Quic Solv or VDC approved degreaser.

Download PDF (252 KB)

More Lexus Manuals


View all Lexus manuals →