Lenovo MetroCluster Service Guide ONTAP 9

Official Lenovo service manual for MetroCluster hardware maintenance with ONTAP 9, covering FC and IP configurations.


Lenovo MetroCluster Service Guide ONTAP 9 - cover page
Brand
Lenovo
Category
Storage
Document type
Service Manual
Language
Chinese
Pages
156
File format
PDF
File size
1.1 MB
Published
15 November, 2026
Updated
15 November, 2026
MD5 checksum
21F185C0F296FCC827E6491ABBCA8CE3

About this manual

This service guide provides step-by-step procedures for maintaining MetroCluster hardware components in ONTAP 9 environments. It covers maintenance tasks such as FC-to-SAS bridge replacement, FC and IP switch upgrades, hot-add and hot-remove storage, and failure recovery scenarios. The guide is designed for technicians managing FC and IP-based MetroCluster configurations, with detailed instructions for replacing hardware, updating firmware, and verifying connectivity.

The document includes chapters on failure scenarios, cabling, port assignments, and reconfiguring switch layouts. It also references other Lenovo documentation for software upgrades and standard shelf maintenance procedures. Copyrighted by Lenovo in 2019 and 2023, it is intended for use with ONTAP 9 systems and includes support contact information for troubleshooting. This manual is written in Chinese.

What's inside

  • Deciding whether to use the MetroCluster Service Guide
  • Where to find procedures for MetroCluster maintenance tasks
  • MetroCluster failure and recovery scenarios
  • Performing FC-to-SAS bridge maintenance
  • Performing FC switch maintenance and replacement
  • Performing IP switch maintenance and replacement
  • Adding, removing, or changing ISL ports nondisruptively
  • Identifying storage in a MetroCluster IP configuration
  • Hot-adding storage to a MetroCluster FC configuration
  • Hot-removing storage from a MetroCluster FC configuration

Frequently asked questions

What is the purpose of this service guide?

This guide describes how to perform maintenance on the MetroCluster hardware components. You should use this guide for maintaining the MetroCluster-specific hardware components in your MetroCluster configuration.

How do I replace a failed power supply module on an FC-to-SAS bridge?

You can hot-replace a failed power supply module. The procedure is detailed in Chapter 4, page 42.

What happens if two MetroCluster IP switches fail at the same site?

RAID SyncMirror of the node stops syncing. HA capability is impacted and the cluster goes out of quorum. Replace the failed switch as necessary.

Where can I find additional information about MetroCluster maintenance?

You can find other MetroCluster documentation in the ONTAP 9 Documentation Center. Additional procedures are referenced in the MetroCluster Transition, Upgrade, and Expansion Guide.

Download PDF (1.1 MB)

More Lenovo Manuals


View all Lenovo manuals →