Kunhang KHCN-TR Series Modbus TCP and RTU Bidirectional Transparent Transmission User Manual

User manual for the Kunhang KHCN-TR Series Modbus TCP and RTU bidirectional transparent transmission module.


Kunhang KHCN-TR Series Modbus TCP and RTU Bidirectional Transparent Transmission User Manual - cover page
Brand
Kunhang
Category
Other network devices
Document type
User Manual
Language
Chinese
Pages
8
File format
PDF
File size
1.1 MB
Published
16 November, 2026
Updated
16 November, 2026
MD5 checksum
230B56DCFE9B147DED805EB427EACCA3

About this manual

Kunhang KHCN-TR Series is an industrial module for bidirectional transparent transmission between standard Modbus TCP and RTU. It uses a 32-bit ARM processor and supports TCP master/RTU slave operation, with up to 8 simultaneous TCP master stations and up to 32 RTU slave stations.

The module has an RS-485 interface with 2400-115200 bps baud rate and software-configurable parity, plus a 10/100 M adaptive Ethernet interface with software-configurable IP address and port. It operates from DC 8-30 V, works from -40 to +85 C, and mounts on a standard 35 mm DIN rail. This manual is written in Chinese.

What's inside

  • Overview
  • Module pictures and interfaces
  • TCP master and RTU slave mode
  • Module parameter configuration

Specifications

Processor32-bit ARM chip
TCP master connectionsUp to 8 simultaneous Ethernet master stations
RTU slave connectionsUp to 32 RTU slave stations
Operating voltageDC 8-30 V (recommended DC 24 V)
Power consumptionNot more than 1.5 W at 24 V
Operating temperature-40 to +85 C
RS-485 baud rate2400-115200 bps
RS-485 parityConfigurable via software
Ethernet speed10/100 M adaptive
Ethernet configurationIP address and port configurable via software
MountingStandard 35 mm DIN rail
Supported Modbus function codes01, 02, 03, 04, 05, 06, 15, 16
Default Ethernet parameters (TCP master/RTU slave mode)IP 192.168.1.126, gateway 192.168.1.1, port 502
Default RS-485 parameters (TCP master/RTU slave mode)9600, N, 8, 1
Default RS-485 parameters (RTU master/TCP slave mode)Device address 1, 9600, N, 8, 1
Default Ethernet parameters (RTU master/TCP slave mode)192.168.1.126, gateway 192.168.1.1

Frequently asked questions

How do I put the module into parameter configuration mode?

Connect the two CONFIG terminals with a wire, then power on; the indicator light flashes quickly twice.

What are the default Ethernet parameters in TCP master/RTU slave mode?

IP address 192.168.1.126, gateway 192.168.1.1, and port 502.

Which Modbus function codes does the module support?

It supports function codes 01, 02, 03, 04, 05, 06, 15, and 16.

How many stations can connect in TCP master/RTU slave mode?

Up to 8 TCP master stations and up to 32 RTU slave stations.

Download PDF (1.1 MB)

More Kunhang Manuals


View all Kunhang manuals →