Quick start guide for JVA Jumbo Mains/Battery (JMB) series electric fence energizers: installation, typical fence setup and Virtual Keypad access.
This quick start guide from JVA Technologies covers the Jumbo Mains/Battery (JMB) series of electric fence energizers. The series consists of 6 models: JMB32-ZM1 (PTE2401), JMB32-ZM2 (PTE2402), JMB32-ZM50 (PTE2400), JMB25-ZM1 (PTE2404), JMB25-ZM2 (PTE2405) and JMB25-ZM50 (PTE2403), rated at 46J or 36J with power or sector loop monitoring. The guide gives the installation steps, including mounting the enclosure, wiring low and high voltage cables, connecting a backup battery and arming the energizer.
It also explains the typical fence setup for the ZM1, ZM2 and ZM50 variants, earth stake requirements, and how to connect to the built-in Wi-Fi Virtual Keypad using a phone, tablet or laptop. The complete manual is referred to www.jva-fence.com/jmb.
| Number of models in series | 6 |
|---|---|
| Highest stored energy | 46J |
| Earth stakes required | At least three, up to ten depending on soil conditions |
| Ground voltage target | Less than 0.4kV |
| Default Wi-Fi password | jvasecure |
| Default Installer PIN | 012345 |
| Virtual Keypad address | 192.168.4.1 |
| Wi-Fi SSID format | JVA_Jumbo_xxxxxx (xxxxxx = serial number) |
The default password is jvasecure. The energizer's SSID appears as JVA_Jumbo_xxxxxx, where xxxxxx is the serial number.
Connect to the energizer's Wi-Fi and type 192.168.4.1 into your device's browser. You are then directed to the Virtual Keypad.
At least three and up to ten may be required depending on soil conditions; keep adding stakes until the ground voltage reads less than 0.4kV.
The series consists of 6 models, from JMB25-ZM1 to JMB32-ZM50, rated at 36J or 46J.