Jinzao JZIot-G10/G20 IoT Weighing Indicator User Manual

User manual for the Jinzao JZIot-G10/G20 IoT weighing indicator, covering setup, calibration, keypad operation, wiring, indicators, and error codes.


Jinzao JZIot-G10/G20 IoT Weighing Indicator User Manual - cover page
Brand
金凿
Category
Other
Document type
User Manual
Language
Chinese
Pages
8
File format
PDF
File size
419 KB
Published
16 November, 2026
Updated
16 November, 2026
MD5 checksum
5B6AD0382E9C7F13822ED7362874A64D

About this manual

The JZIot-G10/G20 is a multi-purpose weighing display indicator intended for dry mortar silos, cement silos, hopper scales, platform scales, and waste-sorting weighing. It uses an industrial CPU and a 24-bit Σ-Δ ADC, and has a built-in IoT chip, an RS232-C serial port with DC12V output for third-party GPS modules, and an ABS enclosure rated IP65.

The manual explains parameter setting, material calibration, factory reset, calibration-free setup, zeroing, sensor wiring, keypad functions, front-panel indicators, shortcut keys, and error codes. It also lists technical specifications such as AC220V±20% 50Hz power, less than 10W consumption, -20°C to 50°C operating temperature, and a 0 to 999,999 display range. This manual is written in Chinese.

What's inside

  • Overview
  • Features
  • Technical Specifications
  • Hardware System Architecture
  • User Operation Instructions
  • Sensor Wiring
  • Keypad Instructions
  • Front Panel Indicators
  • Shortcut Keys
  • Error Codes

Specifications

Power supplyAC 220 V ±20%, 50 Hz
Power consumptionLess than 10 W
Operating temperature-20 °C to 50 °C
Display range0 to 999,999
Display division1, 2, 5, 10, 20, 50
Protection ratingIP65
ADC signal range-16 mV to 18 mV
Maximum sampling rate50 samples/s
Display0.8-inch ultra-bright red digital tube
Capacity range50 to 1000 tons

Frequently asked questions

What does Err03 mean when I press Zero?

Err03 means the current weight is outside the zeroing range, so manual zeroing is not allowed.

How can I restore the factory settings?

Long-press the Confirm key for 5 seconds to restore the weighing parameters to factory settings, equivalent to function 7.

What is the standard sensor sensitivity value?

The standard sensor sensitivity value is 2.00000mV/V; non-standard sensors may use other values such as 1.50000mV/V.

How can I check whether a sensor is damaged with a multimeter?

Measure the input resistance across the red and black wires and the output resistance across the green and white wires; if the readings do not match 380±5Ω and 350±5Ω, the sensor is damaged.

Download PDF (419 KB)