Jiangsu Zhenhua Xinyun Electronics Capacitor Selection Guide

Jiangsu Zhenhua Xinyun Electronics capacitor selection guide covering capacitor parameters, test conditions, and application and derating guidelines.


Jiangsu Zhenhua Xinyun Electronics Capacitor Selection Guide - cover page
Brand
Jiangsu Zhenhua Xinyun Electronics
Category
electronic components
Document type
Product Leaflet
Language
Chinese
Pages
76
File format
PDF
File size
4.1 MB
Published
17 November, 2026
Updated
17 November, 2026
MD5 checksum
9887AA8F5F740B748482BDF8E48D6625

About this manual

This capacitor selection guide from Jiangsu Zhenhua Xinyun Electronics describes the company and explains capacitor symbols, terminology, test conditions, and capacitance tolerance markings. It lists design factors such as temperature, humidity, voltage, vibration, current, and mounting.

The application guide covers reverse voltage limits, ripple voltage and ripple current, derating design, series protection resistors, and low-impedance circuits for tantalum and aluminum electrolytic capacitors. It also includes a table of allowable power loss and temperature derating factors for molded chip solid tantalum capacitors. This manual is written in Chinese.

What's inside

  • Company Profile
  • Capacitor Parameter Symbols
  • Capacitor Terminology
  • Capacitor Test Conditions
  • Capacitance Tolerance and Marking Codes
  • Designer Selection Factors
  • Electrolytic Capacitor Application Guide
  • Reverse Voltage
  • Ripple Voltage and Ripple Current
  • Derating Design

Specifications

Capacitance and Dissipation Factor Test Frequency120 Hz
ESR Test Frequency100 kHz (or specified frequency)
Leakage Current Reading Time5 minutes
Capacitance Tolerance Marking CodesJ = ±5%, K = ±10%, M = ±20%
Solid Chip Tantalum Reverse Voltage at 25°C≤10% UR or 1 V, whichever is lower
Solid Chip Tantalum Reverse Voltage at 85°C≤5% UR or 0.5 V, whichever is lower
Solid Chip Tantalum Reverse Voltage at 125°C≤1% UR or 0.1 V, whichever is lower
Recommended Series Protection ResistanceGreater than 0.1 Ω/V
Manganese Dioxide Solid Tantalum Derating at ≤85°CGenerally 65% UR or less
Conductive Polymer Chip Aluminum Derating at ≤85°CGenerally 90% UR or less

Frequently asked questions

What test frequency is used for capacitance and dissipation factor?

The guide specifies a measurement frequency of 120 Hz for capacitance and dissipation factor tests.

What reverse voltage is allowed for solid chip tantalum capacitors at 25°C?

At 25°C, the allowed reverse voltage is no more than 10% of the rated voltage or 1 V, whichever is smaller.

What series resistance is recommended to limit surge current?

The guide recommends a series resistance greater than 0.1 Ω/V.

How should manganese dioxide solid tantalum capacitors be derated at 85°C or below?

At 85°C or below, the guide generally recommends derating to 65% of the rated voltage or less.

Download PDF (4.1 MB)