JDW Draughting Services Project 09E-25-00 Paddle Steam Engine Eccentric Crank Pin Crank Disc Drawings

Engineering drawing sheet for the eccentric crank pin and crank disc of a 2x1 cylinder model paddle steamer steam engine, with bill of materials and notes.


JDW Draughting Services Project 09E-25-00 Paddle Steam Engine Eccentric Crank Pin Crank Disc Drawings - cover page
Brand
JDW Draughting Services
Category
Other
Document type
Parts List
Language
English
Pages
1
File format
PDF
File size
186 KB
Published
17 November, 2026
Updated
17 November, 2026
MD5 checksum
2D7F48A676B4C286670C85828EDB9F10

About this manual

This is drawing sheet 02 of 06 from JDW Draughting Services (J.A.M. de Waal, Papakura, New Zealand) for project No 09E-25-00, described on the sheet as "A 2x1 cylinder steam engine with reverser for a paddle steamer". The sheet covers the eccentric crank pin and crank disc, shown in one left-hand and one right-hand version (1-01.1, 1-01.3) with dimensions, radii and a 10 mm thick disc drawn at scale 1:3 and 1:2, marked MS/ALU for material.

The sheet also contains the bill of materials, parts and assemblies for the paddle engine (base plate, frame plates, cylinders, crosshead guides, steam chest, crankshaft, eccentric sheave and strap, paddle wheel crank disc and fasteners), plus lists of material and drawing abbreviations and general builder notes. The notes state that all drawings are in metric measurements, that specified materials are indicative only, and that the original article and drawings were first published in the "Model Engineer" magazine of November 1955 under the title "Power by Paddles" by E.T. Westbury.

What's inside

  • Eccentric crank pin and crank disc details
  • Bill of materials, parts and assemblies
  • Material abbreviations
  • Other abbreviations
  • Notes
  • Drawing contents

Specifications

Handed versions1 off left hand, 1 off right hand
Crank disc thickness10 mm
Measurement unitsMetric

Frequently asked questions

What engine is shown in this drawing set?

The sheet describes a 2x1 cylinder steam engine with reverser for a paddle steamer.

Where were the original drawings first published?

The original article and drawings were first published in the "Model Engineer" magazine of November 1955, under the title "Power by Paddles" by E.T. Westbury.

Must the builder use the materials specified on the drawings?

No. The notes say the materials specified on the drawings are indicative only and the builder can make his or her own material choice.

Are the dimensions metric?

Yes, note 0 states that all drawings are in metric measurements.

Download PDF (186 KB)