Iconotech Case Printer Section 8 Troubleshooting Guide

Troubleshooting guide for Iconotech case printers covering print cylinder, ink delivery, film loading, case feeder and drive system problems with corrective…


Iconotech Case Printer Section 8 Troubleshooting Guide - cover page
Brand
Iconotech
Category
Print Machinery
Document type
Service Manual
Language
English
Pages
3
File format
PDF
File size
87 KB
Published
17 November, 2026
Updated
17 November, 2026
MD5 checksum
28E2104274246D557537621E19355118

About this manual

This is Section 8 of an Iconotech troubleshooting guide. It presents problems in a three-column format: symptom, problem and corrective action, covering print cylinder and ink delivery problems, film load problems, case feeder problems and drive system problems.

Corrective actions include replacing tubing with Iconotech type tubing, using only Iconotech ink, adjusting rollers, synchronizing drive chains and checking the air supply. For specific adjustment procedures, the guide refers readers to the "Adjustment Procedures" in Section 7.

What's inside

  • Troubleshooting
  • Print Cylinder/Ink Delivery Problems
  • Film Load Problems
  • Case Feeder Problems
  • Drive System Problems
  • Adjustment Procedures (Section 7)

Specifications

Minimum air supply pressure60 PSI
Air system minimum pressure setting if supply drops below 60 PSI80 PSI

Frequently asked questions

What causes poor print on the Iconotech case printer?

Possible causes include an empty ink bottle, a blocked or worn ink-in hose, wrong type or size tubing, tubing installed backwards, a shaft pin not pushed completely into the cylinder, or use of non-Iconotech ink.

Why will the print cylinder not raise?

The guide lists air pressure too low or a sticking valve. It says to make sure the air supply to the case printer is 60 PSI minimum and to replace the valve if it is sticking.

Why does the case printer not start?

Possible causes are a malfunctioning Plexiglas lid interlock switch, an open emergency stop switch contact or a blown fuse.

Why do the drive chains make excessive noise?

The drive chain may not be properly adjusted on the drive side, the drive chains may not be synchronized, chain tension may be too tight, or the feed end drive chain sprockets may not be aligned with the chain track.

Download PDF (87 KB)