The manual provides safety instructions, installation steps, operation procedures, and maintenance guidelines for the YTC338 vacuum oil filter machine.
The YTC338 vacuum oil filter machine is designed for oil purification in turbines, hydraulic systems and similar industrial equipment. It removes water, particles and gases to keep oil clean and maintain reliable operation.
The document covers safety precautions, installation preparation, startup operation, routine maintenance, and includes technical specifications and additional reference materials. Follow the listed procedures to ensure safe and efficient use of the equipment. This manual is written in Chinese.
| Flow rate (L/min) | 50‑350 |
|---|---|
| Working temperature (°C) | 10‑80 |
| Working pressure (MPa) | ≥0.3 |
| Maximum vacuum degree (Pa) | ≤‑180 |
| Water content (mg/L) | ≤50 |
| Flash point (°C) | ≥188 |
| Inlet pipe diameter (mm) | 25‑60 |
| Dimensions (L×W×H, m) | 1.2×0.95×1.4 |
Read the safety notice, ensure the machine is properly grounded, use the specified fuse, avoid touching live parts, and do not operate the unit without its cover.
Close all valves, turn on the main power, start the vacuum pump until the pressure reaches –0.09 MPa, then open the inlet valve and follow the valve sequence to begin filtration.
Stop the machine for at least 10 minutes, set the temperature controller to zero, close the inlet valves, stop the vacuum pump, drain the vacuum tank, and clean or replace filter elements as needed.