Hubbell HBL6750 Surface Metal Raceway Connectors and Accessories Installation Instructions

Installation instructions for Hubbell HBL6750 surface metal raceway connectors and accessories, including entrance end, wall box, take off, and panel cover…


Hubbell HBL6750 Surface Metal Raceway Connectors and Accessories Installation Instructions - cover page
Brand
Hubbell
Category
Other products
Document type
Installation Guide
Language
English
Pages
2
File format
PDF
File size
59 KB
Published
16 November, 2026
Updated
16 November, 2026
MD5 checksum
520C0D133E0FE0B0E0C09D552A9C8BCD

About this manual

This document provides installation instructions for Hubbell HBL6750 surface metal raceway connectors and accessories. It covers entrance end fittings, wall box connectors, take off connectors, panel covers, and related HBL6750/HBL4750 raceway connections.

Installation must be performed by a qualified electrician in accordance with applicable electrical codes. The raceway is for indoor use only; power must be disconnected before installation, and all bases must be securely fastened to the mounting surface.

What's inside

  • Surface metal raceways HBL6750 connectors and accessories
  • Entrance end fitting installation
  • Wall box connector installation
  • Take off connector installation
  • Panel cover installation
  • General information and safety
  • Knockout removal
  • Coupling and cover installation

Specifications

Wall fastener#8 flat head fasteners with 5/16 in (8 mm) head size
Maximum gap between raceway bases1/16 in (1.5 mm)
Panel cover minimum dimension2.03 in (51.5 mm) minimum

Frequently asked questions

Who may install this raceway system?

It must be installed by a qualified electrician in accordance with applicable electrical codes and the included instructions.

Is the raceway for indoor or outdoor use?

It is for indoor use only.

What is the maximum gap allowed between raceway bases?

The maximum gap is 1/16 inch (1.5 mm).

How is a knockout removed?

Place the tip of the tool at the shown position and strike the end of the tool until the knockout is removed.

Download PDF (59 KB)

More Hubbell Manuals


View all Hubbell manuals →