Host Engineering H0/H2/H4-ECOM100 Ethernet Communications Module DHCP & HTML Configuration

This Host Engineering H0/H2/H4-ECOM100 chapter covers DHCP setup, static IP assignment, and HTML configuration using NetEdit3 or a web browser.


Host Engineering H0/H2/H4-ECOM100 Ethernet Communications Module DHCP & HTML Configuration - cover page
Brand
Host Engineering
Category
Communications equipment
Document type
User Manual
Language
English
Pages
6
File format
PDF
File size
513 KB
Published
16 November, 2026
Updated
16 November, 2026
MD5 checksum
92F6CA2E3DD19B80C1C56CAAEE1D9B65

About this manual

This document is Chapter 6 of the Ethernet Communications Modules, 3rd Edition, Rev. F manual. It describes how to configure the Host Engineering H0/H2/H4-ECOM100 Ethernet communications module using DHCP or a static IP address.

Users can assign network settings through NetEdit3 or the module's HTML configuration page, including module ID, IP address, subnet mask, gateway, and peer-to-peer or Modbus TCP client parameters.

What's inside

  • H0/H2/H4-ECOM100 DHCP
  • Using HTML Configuration
  • Disabling DHCP and Assigning a Static IP Address
  • Connecting to the H0/H2/H4-ECOM100
  • Module ID
  • IP Configuration
  • Firmware Updates
  • Peer to Peer
  • Port Number
  • Unit ID

Specifications

Modbus TCP port502
Module IDMust be unique for each ECOM
Address zeroNot for communications

Frequently asked questions

Can DHCP be disabled and a static IP assigned?

Yes, using NetEdit3 or the module's HTML Configuration page.

What port do Modbus TCP devices use?

Modbus TCP devices respond to and send on port 502.

How are configuration changes saved to the module?

Clicking the Send button writes the entry or change to the module's flash memory.

Download PDF (513 KB)