Instruction manual for High Lift L-220-HD and L-270-HD tote lifters: specifications, safety, installation and adjustment, troubleshooting, and parts lists.
This instruction manual covers the High Lift hand truck (tote lifter) in models L-220-HD and L-270-HD. It gives the rated lifting capacity, fork dimensions and heights, lifting and descending speeds, net weight, and the number of strokes needed to raise the L-270-HD to its maximum height. Safety instructions warn against putting hands or feet under the fork, working on slopes, side-loading, transporting persons, and quick lifting of loads over 660 lbs.
The manual explains installation and adjustment: replacing the oil-sealing screw with the air screw (part No. 158), assembling the handle with M10 nuts and spring washers, and setting the release lever's three positions using the lock nut and adjusting screw. It also includes procedures for releasing air from the pump and adding ISO VG22 hydraulic oil, a troubleshooting guide, and exploded views with part lists for the fork and pump assembly.
| Rated lifting capacity | 3,000 lbs. |
|---|---|
| Max. fork height | 31 ½ inch |
| Min. fork height | 3 3/8 ±1/16 inch |
| Fork length | 45 inch |
| Fork width (outside) | 20 ½ inch (L-220-HD); 26 ¾ inch (L-270-HD) |
| Fork width (inside) | 7 ¾ inch (L-220-HD); 14 inch (L-270-HD) |
| Lifting speed | 3/8 inch/stroke |
| Descending speed | 2.25 inch/second |
| Net weight | 240 lbs. (L-220-HD); 260 lbs. (L-270-HD) |
| Strokes to maximum height, L-270-HD | 65 single speed; 18 two speed |
| Down time without load | 14 secs. |
| Hydraulic fluid | ISO VG22 or equivalent |
The rated lifting capacity is 3,000 lbs. for both models.
The handle is assembled on the Handle Base (No. 181) with 3 pieces of M10 Nut (No. 185) and spring washer, and the chain's Eye Bolt (No. 110) is put in the slot at the front end of the Pendulum Arm (No. 112).
The guide lists a low oil level, air in the hydraulic system, or an improperly adjusted nut as possible causes; add hydraulic oil, operate the handle several times to bleed the system, or adjust the adjusting nut.
Use hydraulic fluid of ISO VG22 quality or equivalence; mixing different fluids is prohibited.