HH-66 Vinyl Cement Tarp Repair Guide

Guide to patching small holes in vinyl tarps with HH-66 Vinyl Cement and an 18oz vinyl patch, covering materials, safety and technical data.


HH-66 Vinyl Cement Tarp Repair Guide - cover page
Brand
HH-66
Category
Chemical products
Document type
User Manual
Language
English
Pages
4
File format
PDF
File size
320 KB
Published
16 November, 2026
Updated
16 November, 2026
MD5 checksum
5E7F953164292A863FFDFBC04394C9C0

About this manual

This four-page guide explains how to repair a torn vinyl tarp using HH-66 Vinyl Cement and an 18oz vinyl patch instead of buying a new tarp. It describes the cement as an adhesive for bonding vinyl coated and vinyl laminated fabrics, notes that it is not for use on polyethylene or propylene vinyls, and lists common uses such as tarpaulins, pool covers, awnings, inflatables and liners.

The guide lists the necessary materials and safety precautions, then walks through preparing the patch and tarp, applying the glue, rolling the patch down and letting it cure. A technical data section gives the base, color, solvent, viscosity, application method, solids, net weight, temperature range, tack life, shelf life and flash point. The document ends with the Mytee Products address and phone number in Aurora, Ohio.

What's inside

  • Introduction
  • Common Uses
  • Necessary Materials
  • Safety Precautions
  • Environmental Precautions
  • Technical Data
  • Preparing Materials
  • Applying the Glue
  • Conclusion

Specifications

BaseThermoplasticelastomer
ColorClear
SolventMEK-Toluene-Acetone blend
ViscosityMedium, 1100-1300 cps
ApplicationBrush or roller
Solids15% approximately
Net Weight8 lbs approximately
Temperature Range-30°F to 150°F
Tack Life2-5 minutes
Shelf Life18 months
Flash Point22°F

Frequently asked questions

What temperature range does HH-66 Vinyl Cement handle?

The stated temperature range is -30°F to 150°F, and the guide says extreme weather and temperature will not affect the cement.

How long does the glue take to cure after the patch is applied?

The glue takes up to 24 hours to cure, so the tarp and patch should sit in a dry area for one day.

How long should I wait after applying the glue before placing the patch?

Wait 2-5 minutes for the glue to dry; the patch can go on while the glue is wet, but bonding is best once it has slightly dried.

On which vinyls should HH-66 Vinyl Cement not be used?

It is not for use on polyethylene or propylene vinyls.

Download PDF (320 KB)