User manual for the Hennessy Vero Series V200 2D/3D wheel balancer, covering safety, set-up, operation, calibration, and maintenance instructions.
This manual covers the Hennessy Vero Series V200 2D/3D wheel balancer from Hennessy Industries Inc., the manufacturer of AMMCO, COATS and BADA automotive service equipment. It instructs supervisors and operators to read the instructions before placing the unit in service and to keep them in a binder near the machine for reference.
The document is organized into safety instructions, set-up instructions, operation instructions, and maintenance instructions. Operation topics include mounting a wheel on the balancer shaft, entering wheel dimensions, dynamic and static balancing, corrective weight placement, ProBalance technology, and machine calibration, followed by troubleshooting procedures and a glossary. The machine's motor unit contains a Class IIIa laser with a maximum output of less than 5 mW.
| Laser class | Class IIIa |
|---|---|
| Laser maximum output | less than 5 mW |
| Laser wavelength | 630-680 nm |
The owner must provide protective goggles, safety glasses, or a face shield, and the operator must wear them. Everyday glasses only have impact resistant lenses and are not safety glasses.
It includes a STOP key for stopping the wheel under emergency conditions, a high-impact plastic hood guard, and a hood switch interlock system that prevents starting unless the guard is lowered.
The hood switch interlock system stops the wheel whenever the guard is raised and prevents the machine from starting if the guard is not lowered.
The hub nut must engage the arbor for not less than four turns and be firmly tightened before spinning the wheel.