The Hawkridge Hawk 5E Operators Manual covers operation and programming of the microprocessor-based display/control unit for mobile volumetric mixer operators.
The Hawkridge Hawk 5E is a microprocessor-based display/control unit engineered for mobile volumetric mixer operators. It supports programming of up to 30 mix presets and provides discharge information, printout, and logging capability, including volume, sand and stone weight, water amount, and batch control status.
This manual describes the display keys, run display screens, programming steps, master reset, general set-up menu, print functions, and calibration procedures for the admix flowmeter and water meter. It also lists connector pin outs.
| Mix presets | up to 30 |
|---|---|
| Communication interface | RS232 serial |
| Volume units | cubic yards or meters |
| Water volume units | litres or US gallons |
| Strength units | PSI, MPA, or N |
It allows programming of up to 30 mix presets.
It sends an RS232 serial communication stream to a printer, serial cell modem, computer, or other hardware.
Press the RST key while powering up the unit to reset the totalized pulse count.
The engineering units for concrete strength can be set to PSI, MPA, or N.