Hardrace 7786 Accessory A Rear Sway Bar Installation Guide

Hardrace Accessory A rear sway bar (part no. 7786) installation guide with parts list, three fitting steps and vehicle application for Ford Fiesta '14.


Hardrace 7786 Accessory A Rear Sway Bar Installation Guide - cover page
Brand
Hardrace
Category
Car parts
Document type
Installation Guide
Language
Chinese
Pages
1
File format
PDF
File size
362 KB
Published
10 November, 2026
Updated
10 November, 2026
MD5 checksum
176EEAC941C0167609EE459E075E8A2F

About this manual

This one-page Hardrace installation guide covers the rear sway bar set listed as Accessory A, part number 7786. It starts with a contents list and the hardware supplied (M12 and M10 bolts, spring washers, washers, Accessory A and Accessory B), then gives three numbered installation steps with bilingual Chinese/English instructions. Vehicle application is given as Ford Fiesta '14.

The steps describe lifting the vehicle and removing the two rear wheels, supporting the left or right lower spring seat with a jack stand, removing the 15mm bolt under the coilover and inserting Accessory A, then fixing Accessory B (R/L) with washers and a 19mm nut left loose for later adjustment. The last note says the holes must be aligned, the 14mm nuts tightened first and then the 19mm nuts. This manual is written in Chinese.

What's inside

  • Contents
  • Rear Sway Bar
  • Installation tips
  • STEP 1
  • STEP 2
  • STEP 3
  • Vehicle Applications

Specifications

Part number7786
Vehicle applicationFord FIESTA '14
Bolt 1M12x1.25-19x13.5mm, 4 pcs
Bolt 2M10x1.25-14x9mm, 4 pcs
Spring washer4 pcs
Washer4 pcs
Accessory A2 pcs
Accessory BRight and left (R/L)

Frequently asked questions

Which vehicle does this Hardrace rear sway bar fit?

The guide lists the vehicle application as Ford Fiesta '14.

What is the first installation step?

Safely lift the vehicle and remove the two rear wheels, then support the RH/LH lower spring seat with a jack stand.

Which nut should be tightened first?

Tighten the 14mm nuts first and the 19mm nuts afterwards.

Why should the 19mm nut be left loose in step 2?

So that the position can still be adjusted while installing the sway bar and aligning the holes.

Download PDF (362 KB)

More Hardrace Manuals


View all Hardrace manuals →