User manual for the Half Power SBC50 solar charge controller for LED lamps, covering safety, installation, modes, operation and troubleshooting.
This manual covers safety instructions, installation, connection sequence, display and load work mode settings, operation, troubleshooting and technical data for the Half Power SBC50 solar charge controller for LED lamps.
It describes 12V or 24V system support, LED lamp loads up to 50W, PWM charging with float, boost and equal stages, temperature compensation, overload and short-circuit protection, and low-voltage disconnect values. This manual is written in Chinese.
| Item No | SBC50 |
|---|---|
| Rated charging current | 10A |
| Rated load power | ≤50W |
| System voltage | 12V or 24V |
| No-load current | ≤6 mA |
| Over-voltage protection | 17V (12V), 34V (24V) |
| Work temperature | -35°C to +55°C |
| Boost charging voltage | 14.6V (12V), 29.2V (24V) |
| Equal charging voltage | 14.4V (12V), 28.8V (24V) |
| Float charging voltage | 13.7V (12V), 27.4V (24V) |
| Temperature compensation | -3 mV/°C/2V |
| Low voltage disconnect | 11.1V (12V), 22.2V (24V) |
| Overload and short-circuit protection | 1.25x rated current for 60 seconds; 1.5x rated current for 5 seconds |
It supports 12V or 24V systems.
The rated load power is up to 50W.
Pure light control, light control with timer off, normal control, and test mode.
The controller switches off the load at once.
Yes, it uses PWM charge modes with float, boost and equal charge stages.