GeoSIG GXR-GPS-485 User Manual

The GeoSIG GXR‑GPS‑485 User Manual provides operation principles, installation, wiring, mounting and configuration instructions for the GPS module.


GeoSIG GXR-GPS-485 User Manual - cover page
Brand
GeoSIG
Category
Other Electronics
Document type
User Manual
Language
English
Pages
12
File format
PDF
File size
937 KB
Published
06 October, 2026
Updated
06 October, 2026
MD5 checksum
7FF2CEA1AF66C69853BBB36216EBEE86

About this manual

This manual describes the principle of operation and installation of the GeoSIG GXR‑GPS‑485 GPS module, including connector pin assignments, cable connections, mounting recommendations and configuration steps for synchronization with GeoSIG instruments. It also covers safety warnings and provides a brief troubleshooting guide.

Key sections cover the 8‑pin RS‑485 connector pinout, cable types and maximum lengths, mechanical mounting of the GPS box, and detailed procedures for checking GPS status with GSR‑xx and CR‑5P instruments using GeoDAS software.

What's inside

  • Introduction
  • GPS Main Connector Pin Assignment
  • Mating Connector at the Instrument Side
  • Cable Connection GXR‑GPS
  • Cable Connection GXR‑GPS‑485
  • Mounting the GPS Box
  • Configuration and Checking

Specifications

Maximum cable length (standard GXR‑GPS)70 m
Maximum cable length (optional GXR‑GPS‑485)1000 m
Power supply voltage12 V

Frequently asked questions

How can I verify that the GPS is enabled after installation?

Open the Instrument’s Date and Time tab in GeoDAS; the GPS status should read “Enabled”.

What sky visibility is required for mounting the GPS box?

At least 75 % of the sky must be visible from the GPS box location.

What connector type is used for the GXR‑GPS‑485 module?

The GXR‑GPS‑485 uses an 8‑pin RS‑485 connector (BLA 8 SN OR).

Download PDF (937 KB)