GEMO PC107/PC109 Auto-Tune PID Temperature Step Controller User Manual

GEMO PC107/PC109 user manual for a panel-mount auto-tune PID temperature step controller with heat and alarm outputs, J/K/S/Pt100 inputs and step programming.


GEMO PC107/PC109 Auto-Tune PID Temperature Step Controller User Manual - cover page
Brand
Gemo
Category
Automation control Equipment
Document type
User Manual
Language
English
Pages
7
File format
PDF
File size
387 KB
Published
17 November, 2026
Updated
17 November, 2026
MD5 checksum
286AEAA08B3F1C6F7F0C8F11BDC0921C

About this manual

The GEMO PC107/PC109 is a microprocessor-based PID temperature step controller with HEAT and ALARM outputs, intended for basic temperature control applications in light industrial environments. It accepts selectable J, K or S thermocouples or Pt100 sensors, supports ON-OFF or P, PI, PD and PID control, and provides auto-tuning for PID parameters.

This English manual covers technical and general specifications, installation and safety warnings, programming of system parameters, step heat set values and step timer values, and the START, STOP and PAUSE commands for step control. It also describes how to start auto-tuning by entering code 262.

What's inside

  • Technical Specification
  • Installation, Use and Warnings
  • General Specification
  • Programming System Parameters
  • Programming Step Heat Set Values
  • Programming Step Timer Values
  • Starting Step Control; "START" Command
  • Resetting (Stopping) Step Control; "STOP" Command
  • Pausing Step Control Temporarily; "PAUSE" Command
  • Starting Auto-Tuning

Specifications

DimensionsPC109: 96 x 96 mm; PC107: 72 x 72 mm
Panel cut-outPC109: 91 x 91 mm; PC107: 68 x 68 mm
Display4 digits 7 segment (PV), 4 digits 7 segment (SV)
Sensor typeJ, K, S type thermocouple or Pt100, selectable
Accuracy±0.3% over full scale
Control formON-OFF or P, PI, PD, PID, selectable
Heat outputRelay (NO + NC), 250 VAC, 2 A resistive load
Supply voltage100..240 VAC, 50-60 Hz; PC107 also 24 VDC/AC
Protection classIP20 according to EN 60529
Operating temperature0 .. 50 °C

Frequently asked questions

Which sensor types can the PC107/PC109 use?

It accepts J, K or S type thermocouples or Pt100 sensors, selectable in the input parameter.

How many step heat set values can be programmed?

Up to 20 steps can be selected, with each step having a heat set value.

What is the maximum timer setting for each step?

The step timer can be set up to 18 hours per step.

How do I start auto-tuning?

Enter code 262 to start auto-tune; "tunE" blinks during the procedure.

Download PDF (387 KB)