Quick start guide for the Gecko Alliance in.yj-2-V3™ controller: power, outputs, panel setup, spa configuration, wiring, voltage, and GFCI settings.
The Gecko Alliance in.yj-2-V3™ North American Version quick start guide covers connecting all outputs and the control panel, connecting main power, selecting a spa configuration, and starting the control panel. It lists the initial panel displays and the key presses used to enter configuration menus.
The guide also covers electrical wiring, pump and accessory voltage, breaker current selection, and the configuration options table. It states that connections must be made by a qualified electrician under applicable electrical codes and that the product must be connected to a GFCI-protected circuit. This manual is written in Chinese.
| Minimum water flow | 68.1 L/min (18 GPM) |
|---|---|
| Main power input | 120 V (3 wires) |
| Main power input | 240 V (4 wires) |
| Light output | 12 V DC, 1 A |
| Relay-controlled outputs | Output 1 K7-P; Output 2 K6-P |
| Direct power output | P25 |
| Circulation pump operation | Not relay controlled; runs 24/7 |
Hold the pump 1 key for 30 seconds.
It first displays L 1 or LL 1.
Hold the program key for 20 seconds until the breaker setup menu appears.
The product must always be connected to a circuit protected by a ground fault circuit interrupter (GFCI).