Garmin REACTOR 40 Hydraulic Autopilot Installation Guide

About this manual

The document serves as an installation manual for the Garmin REACTOR 40 Hydraulic Autopilot System. It outlines critical safety information, required tools, and preparation steps before beginning the physical installation on a vessel.

Key sections detail the power and data layout, including specific requirements for NMEA 2000 networks and battery connections. The guide provides detailed instructions for installing the Control Unit (CCU), Electronic Control Unit (ECU), Alarm, and Shadow Drive sensor, along with diagrams for single and dual rudder configurations. This manual is written in Chinese.

What's inside

• Important Safety Information
• Installation Preparation
• Power and Data Layout
• Component Layout
• CCU Installation
• ECU Installation
• Shadow Drive Sensor Installation
• Alarm Installation
• NMEA 2000 Connections
• Installation Procedure

Frequently asked questions

What voltage range must the NMEA 2000 power cable be connected to?

The NMEA 2000 power cable must be connected to a 9 to 16 Vdc power source.

What is the length of the CCU data cable connecting the CCU to the ECU?

The CCU data cable is 5 meters (16 feet) long and cannot be shortened.

What is the minimum distance required between the Shadow Drive sensor and magnetic materials?

The Shadow Drive sensor must be installed at least 305 millimeters (12 inches) away from magnetic materials or devices.