FreshWater Salt System Hot Tub Startup Guide

FreshWater Salt System startup guide: test fill water, fill the spa, add salt, balance and soften water, sanitize, then set the output level and monitor.


FreshWater Salt System Hot Tub Startup Guide - cover page
Brand
FreshWater
Category
Other
Document type
Quick Start Guide
Language
English
Pages
4
File format
PDF
File size
331 KB
Published
16 November, 2026
Updated
16 November, 2026
MD5 checksum
91FE8EF4833209D21CBEB783318F0EB5

About this manual

This four-page startup guide walks through starting up a FreshWater Salt System in a spa: testing the fill water, filling the spa and inserting the salt system cartridge, adding salt to a target of 1,750 ppm, balancing pH and alkalinity, sanitizing with chlorine to a 5 ppm target, softening the water toward a 50 ppm calcium target, and finally setting the salt system output level and monitoring the water.

It includes a salt dose chart by spa capacity from 200 to 600 gallons, a table of salt system parameters with target values and OK ranges, a list of output level settings from Level 0 (system off) to Level 10 (maximum output), and tips such as the 10-day checkup reminder and the note that the system is compatible with chlorine, MPS and silver but not with bromine or BaquaSpa®.

What's inside

  • Test fill water
  • Fill spa
  • Add salt
  • Balance water
  • Sanitize
  • Soften water
  • Set salt system output level & monitor
  • Salt system parameters
  • Tips to get the best performance from your FreshWater Salt System

Specifications

Salt target1,750 ppm (OK range 1,500–2,000 ppm)
Calcium hardness target50 ppm (OK range 25–75 ppm)
Total alkalinity target80 ppm (OK range 40–120 ppm)
pH target7.4 (OK range 7.2–7.8)
Chlorine target3 ppm (OK range 1–5 ppm)
Fill water levelone inch (2.5 cm) above the highest jet
Salt dose for 200 gallons (760 L)4 1/2 cups, output Level 5
Salt dose for 600 gallons (2,280 L)13 3/4 cups, output Level 7

Frequently asked questions

What salt level should I reach when adding salt?

Add salt one cup at a time with the jets running and check with FreshWater Salt Test Strips until the level is around 1,750 ppm; do not exceed that target.

What chlorine level is targeted during startup?

The target during the sanitizing step is 5 ppm; repeat the chlorination process until that level is reached.

What should I do if my calcium hardness is over 75 ppm?

For 75–150 ppm use the Vanishing Act pillow from the startup kit, for 150–300 ppm use Vanishing Act XL or an On The Go portable water softener, and over 300 ppm use an On The Go during the fill.

Can I use bromine with the FreshWater Salt System?

No. The system is compatible with chlorine, MPS and silver, but it is not compatible with bromine or BaquaSpa.

Download PDF (331 KB)

More FreshWater Manuals


View all FreshWater manuals →