Franklin Water Treatment OXY2 & OXY2E Iron Reduction System Instruction Manual

Franklin Water Treatment OXY2 and OXY2E iron reduction system manual covering installation, setup, timer operation, programming, and troubleshooting.


Franklin Water Treatment OXY2 & OXY2E Iron Reduction System Instruction Manual - cover page
Brand
Franklin Water Treatment
Document type
User Manual
Language
English
Pages
24
File format
PDF
File size
1 MB
Published
15 November, 2026
Updated
15 November, 2026
MD5 checksum
277A9FAFC0594F3576310C06100A8C7D

About this manual

The Franklin Water Treatment OXY2 & OXY2E Series Iron Reduction System uses a single filtration tank with an air pocket and a backwashing control valve to oxidize and trap iron from incoming water. The system also reduces manganese and hydrogen sulfide, and the backwash cycle typically begins at 1:00 A.M. to flush accumulated iron to the drain.

This owner's manual covers pre-installation requirements, general installation, timer and display operation, programming, specifications, control valve parts breakdowns, wiring diagrams, and troubleshooting for both OXY2 and OXY2E models.

What's inside

  • Pre-installation Instructions
  • General Installation
  • Installation Instructions
  • OXY2 Timer Operation
  • OXY2E Display and Operation
  • OXY2E Programming
  • Specifications
  • Troubleshooting
  • Control Valve Wiring Diagram
  • Ten Year Limited Warranty

Specifications

Maximum hydrogen sulfide treatment2 mg/L
Minimum pumping rate5 gpm
Maximum water temperature100 °F
Maximum drain line length15 ft
Minimum media tank freeboard14 inches

Frequently asked questions

When does the backwash cycle typically start?

The backwash cycle typically begins at 1:00 A.M.

What minimum pumping rate is required for the jet pump?

The jet pump requires a minimum pumping rate of 5 gpm.

Where should the filter be installed on a private well system?

The filter should be installed after the pressure tank.

Download PDF (1 MB)