Fluke 754 Documenting Process Calibrator HART Mode Users Guide

Fluke 754 HART Mode Users Guide covering HART channel selection, transmitter connection, setup, service operations, trims, loop test, and calibration.


Fluke 754 Documenting Process Calibrator HART Mode Users Guide - cover page
Brand
Fluke
Category
Calibration Components
Document type
User Manual
Language
English
Pages
26
File format
PDF
File size
529 KB
Published
17 November, 2026
Updated
17 November, 2026
Model
754
MD5 checksum
22B6535C7151069109AEC24FF919C841

About this manual

The Fluke 754 Documenting Process Calibrator combines communication and calibration functions in one tool. This guide explains how to use the HART communication mode, in which the Product communicates over its serial HART interface with a HART transmitter. It refers readers to the 753/754 Users Manual for safety information, analog mode instructions, specifications, and general data.

The guide covers HART channel selection, connecting to a HART transmitter, supported and generic transmitters, communication operations, setup and service operations, HART calibration, loop test, output trim, sensor trim, and duplicating a transmitter’s basic information. It notes that some HART transmitter commands are available only with supported devices.

What's inside

  • HART Channel Selection
  • Connect to a HART Transmitter
  • Supported vs. Generic Transmitters
  • Communication Operations
  • Setup Operations
  • Service Operations
  • HART Calibration
  • Loop Test
  • Output Trim
  • Sensor Trim

Specifications

HART channel optionsHART Port or mA Jack
Warranty periodThree years from date of purchase

Frequently asked questions

How do I choose the HART channel on the Fluke 754?

Use Setup mode to select HART Channel, then choose HART Port or mA Jack. The selection is kept in Product memory until changed.

Can a Sensor Trim be done on a generic HART transmitter?

No. A Sensor Trim can only be done on a supported transmitter, while an Output Trim can be done on generic and supported transmitters.

What is the Loop Test used for?

Loop Test sends a command to the transmitter to set its output block to a specified value. It can be used to examine the calibration of the output block or verify an external loop reading device.

Can the Fluke 754 copy basic setup data between transmitters?

Yes. The Product can duplicate Basic Setup data from one transmitter to a different transmitter, including generic and supported transmitters.

Download PDF (529 KB)

More Fluke Manuals


View all Fluke manuals →