Step-by-step instructions for assembling a Fire Pit glass wind guard, with packing list, safety warnings and care tips.
This short instruction sheet shows how to put together a glass wind guard for a fire pit. It starts with a packing list of the glass panels, top and bottom corner connectors, M8 x 10 screws and the supplied hand screw driver, then walks through five assembly steps in which the connectors are screwed to the short and long glass panels.
The final pages give safety warnings - keep the rubber feet on, keep the silicon insert on the set screws, leave a 1/2 gap between the glass panels and never use cracked glass - plus a maintenance note to clean the glass 2-3 times per season and general care advice for the material.
| Screw size | M8 x 10 |
|---|---|
| Gap between glass panels | 1/2 |
| Glass cleaning frequency | 2-3 times per season or as needed |
Two short glass panels, two long glass panels, four top corner connectors, four bottom corner connectors, 16 M8 x 10 screws and one hand screw driver.
Always leave a 1/2 gap between the glass panels.
No. Always check the glass panels for cracks and do not use panels with a crack.
Clean the glass 2-3 times per season or as needed.