ESCO 10601K Inline Preset Pressure Regulator Kit Instruction Manual

Instruction manual for the ESCO 10601K inline preset pressure regulator kit, covering installation on ESCO air/hydraulic pumps and the included 6-inch whip…


ESCO 10601K Inline Preset Pressure Regulator Kit Instruction Manual - cover page
Brand
Esco
Category
Industrial Supply
Document type
User Manual
Language
English
Pages
4
File format
PDF
File size
1.8 MB
Published
17 November, 2026
Updated
17 November, 2026
MD5 checksum
2E8DDCB8EDF2CBF428A3897F0FDCFDD8

About this manual

This instruction manual covers the ESCO Inline Preset Pressure Regulator Kit, model 10601K. The kit contains the ESCO Inline Preset Pressure Regulator (part #10601) and a 6" Whip-Hose (part #10601H). The regulator is made for air/hydraulic pumps and regulates the air pressure the hydraulic pump receives, which is then used to power all ESCO hydraulic tools. The kit helps maintain the manufacturer's recommended working air pressure for operating ESCO air/hydraulic tools and equipment.

The manual lists the tools recommended for installation (a 9/16" wrench, a 3/4" wrench and Teflon tape or an equivalent) and then walks through the steps: removing the air-side plug on a brand new ESCO air hydraulic pump, applying Teflon tape to both ends of the whip hose, attaching the regulator with its directional arrow pointing to the hose end, tightening the regulator and hose with the two wrenches, fitting the hose to the pump's air inlet, adding an air supply nipple to the open regulator port, and attaching the air supply. A safety section warns users to read all dangers, warnings, cautions and instructions and to wear protective gear, and a contact block gives ESCO's address, phone, fax, email and website.

What's inside

  • Product Description
  • Safety Information
  • Tools Needed to Install the ESCO Inline Preset Pressure Regulator
  • Removal of Air-Side Plug
  • Prepare the 6" Whip-Hose
  • Adding the Pressure Regulator to the Whip Hose
  • Properly Tighten Pressure Regulator onto the Whip Hose
  • Properly Tighten Whip Hose onto the Pump
  • Attach Air Supply Nipple
  • Attach Air Supply to Pressure Regulator

Specifications

Kit contentsInline Preset Pressure Regulator (part #10601) and 6" Whip-Hose (part #10601H)
Regulator part number10601
Whip hose part number10601H
Whip hose length6 inches
Tools recommended for installation9/16" wrench, 3/4" wrench, Teflon tape or an equivalent
Air supply nippleNot included with the 10601K kit

Frequently asked questions

What tools are needed to install the ESCO 10601K pressure regulator kit?

ESCO recommends a 9/16" wrench, a 3/4" wrench and Teflon tape or an equivalent.

Which way should the pressure regulator be aligned on the whip hose?

Align the regulator so the directional arrow points to the hose end; the direction of the air reducer affects product performance.

Is an air supply nipple included in the 10601K kit?

No. The manual notes that the air supply nipple is not included with 10601K and must be attached separately.

How can I contact ESCO for more information?

Call toll free at 1-800-352-9852 (US & Canada only) or 352-754-1117, or email [email protected].

Download PDF (1.8 MB)

More Esco Manuals


View all Esco manuals →