Operator's manual for the ENC ENC2A battery charger, covering safety, connection, charging steps, and automatic charging stages for lead-acid batteries.
The ENC ENC2A is a battery charger for lead-acid batteries, including AGM, STD, WET, CAL, and GEL types. The manual provides important safety instructions, personal precautions, preparation steps, charger placement, and DC connection guidance.
It also explains charging with the battery installed in a vehicle or removed from it, AC power connection, estimated charging time, operating features, and the automatic microprocessor-controlled charging stages.
| Model | ENC2A |
|---|---|
| Supported batteries | Lead-acid only, including AGM, STD, WET, CAL, and GEL |
| Charge settings | 2.0 A at 6 V or 12 V |
| Absorption voltage | 14.6 VDC |
| Restart threshold | 12.8 VDC |
| Input voltage | Nominal 110 V |
| Extension cord under 15 m | 0.75 mm2 |
It charges lead-acid batteries only, including AGM, STD, WET, CAL, and GEL types.
The selectable settings are 2.0A–6V and 2.0A–12V.
The charger has not detected a properly connected battery, and charging will not begin until one is detected.
Use the formula: Amp Hour Rating of Battery × Percent of Charged Needed × 1.25, divided by the selected amp setting.