EK Water Blocks EK-FB EVGA X58 LE Water Block Installation Guide

Installation guide for the EK Water Blocks EK-FB EVGA X58 LE water block, covering motherboard preparation, thermal pads, mounting and fitting connection.


EK Water Blocks EK-FB EVGA X58 LE Water Block Installation Guide - cover page
Brand
EK Water Blocks
Category
Other Computer Accessories
Document type
Installation Guide
Language
English
Pages
2
File format
PDF
File size
613 KB
Published
16 November, 2026
Updated
16 November, 2026
MD5 checksum
9A43B6CC57858A61CF2ADBA07D0EFDE2

About this manual

This installation and mounting manual explains how to install the EK Water Blocks EK-FB EVGA X58 LE water block on an EVGA X58 LE motherboard. It is intended for expert users and warns that improper installation may damage equipment; the document was released on 7 August 2009 and refers readers to www.ekwaterblocks.com for updates.

The guide covers removing the stock cooler, cleaning the PCB, applying thermal compound, cutting and placing thermal pads, attaching standoffs, mounting the block, checking contact, and connecting fittings to the water circuit. It also lists required tools and the M2.5x6 screws and insulating washers used for mounting.

What's inside

  • General information
  • Preparing your motherboard
  • Removing stock cooler
  • Cleaning the PCB
  • Applying thermal compound
  • Cutting thermal pads
  • Placing thermal pads on motherboard
  • Attaching block to motherboard
  • Checking for contacts
  • Positioning fittings and connecting to water circuit

Specifications

Thermal pad dimensionsOne 90 x 15 x 1 mm pad and two 30 x 25 x 0.5 mm pads
Standoff thickness2.5 mm
Mounting screws6 screws, M2.5 x 6 DIN7985
FittingsHigh flow fittings

Frequently asked questions

What tools are required for installation?

The required tools are scissors and a Philips screwdriver.

How is the thermal compound applied?

The guide says to lightly coat the Northbridge and recommends non-conductive MX-2 applied in a cross form.

Does the water block use a spring mounting system?

No. The block does not use a spring mounting system, so all screws must be tightened equally and carefully.

What should be used with the M2.5x6 mm screws?

The enclosed insulating washers should be used on all M2.5x6 mm screws.

Download PDF (613 KB)

More EK Water Blocks Manuals


View all EK Water Blocks manuals →