EAT C-Sharp Turntable User Manual

German user manual for the EAT C-Sharp turntable: setup, tonearm assembly, speed control, technical data and service information.


EAT C-Sharp Turntable User Manual - cover page
Brand
E.A.T.
Category
Hi-Fi
Document type
User Manual
Language
German
Pages
20
File format
PDF
File size
864 KB
Published
17 November, 2026
Updated
17 November, 2026
MD5 checksum
2383C8755EFC07E74F693B1F9C096A40

About this manual

This is the German-language instruction manual for the EAT C-Sharp turntable, published by Audio Reference GmbH in Hamburg. It opens with a welcome note, a warning to check the packaging and contents immediately after delivery, and information on disposing of packaging and old equipment.

The manual then walks through setup: removing the three transport screws from the carbon part of the chassis, fitting the sub-platter and drive belt, mounting the platter and record puck, and assembling and adjusting the tonearm (cartridge, counterweight and vertical tracking force, output connection, vertical tracking angle, azimuth, antiskating). It ends with levelling the turntable on its adjustable damped feet, starting the motor and switching between 33 and 45 rpm from the external control unit, a technical data table, and sections on warranty, service and troubleshooting. This manual is written in German.

What's inside

  • Parts identification and parts list
  • Controls, functions and connections
  • Transport screws
  • Protective covers, sub-platter and drive belt installation
  • Platter mounting
  • Tonearm assembly
  • Cartridge mounting and wiring
  • Counterweight mounting
  • Vertical tracking force (VTF) adjustment
  • Antiskating device mounting and adjustment

Specifications

Nominal speed33 and 45 rpm
Speed deviation33 rpm ± < 0.08%, 45 rpm ± < 0.09%
Electrical noise-70 dB
Counterweight mass125 g
Suitable cartridge weight, counterweight with additional insert8.5 to 13 g (counterweight 142 g)
Power supplyUniversal switching power supply, 15 V DC, 1.6 A
Dimensions (W x D x H)500 x 400 x 115 mm without connections

Frequently asked questions

How do I start the turntable and change the speed?

Press the 33 U/min button to start the turntable at 33 rpm, press the 45 r.p.m. button to switch to 45 rpm, and press Stby to return to standby.

What has to be done before mounting the sub-platter and platter?

The three transport screws must be removed from the carbon part of the chassis before the sub-platter, drive belt and platter are mounted.

How much grease is used to lubricate the main bearing shaft?

A maximum of 0.5 ml, taken from the scale on the supplied syringe of grease.

Which cartridges fit the counterweight without the additional insert?

Without the additional insert the counterweight is suited to cartridges from 5 to 9 g.

Download PDF (864 KB)