Dorf KIP IS1258A Sink Mixer Plumbers Installation Instructions

Plumbers installation instructions for the Dorf KIP sink mixer (IS1258A), covering flexible tail connections, deck fitting, cartridge and aerator replacement.


Dorf KIP IS1258A Sink Mixer Plumbers Installation Instructions - cover page
Brand
Dorf
Category
Other
Document type
Installation Guide
Language
English
Pages
1
File format
PDF
File size
171 KB
Published
16 November, 2026
Updated
16 November, 2026
MD5 checksum
50A2AFAF810073319BA497BF710E4EA6

About this manual

This document is the plumbers installation instruction sheet (IS1258A, 08/13) for the Dorf KIP sink mixer, water efficient tapware. It lists the numbered parts of the mixer and then walks through fitting the 'O'ring and base ring, screwing in the stud, and assembling the flexible tails to the holes marked 'H' for hot and the remaining hole for cold.

The instructions continue with mounting the mixer over the deck hole using the gasket, fixing plate, stud and fixing nut, and with connecting the flexible tail inlet ends to the hot and cold isolating stop taps. Warnings cover kinking, tension, ultraviolet light and flushing pipework, and separate sections describe the pressure and temperature requirements, deck requirements, replacing the cartridge and replacing the aerator insert.

What's inside

  • Installation
  • Flexible Tail Mixer Connections
  • Flexible Tail Inlet Connections
  • Pressure & Temperature Requirements
  • Deck Requirements
  • Replacing Cartridge
  • Replacing Aerator Insert

Specifications

Static inlet pressure range150-1000 kPa
Maximum hot water temperature80 C
Maximum deck thickness45 mm
Tap body hole in deck34-36 mm
Flow regulated aerator insert5 L/min
Minimum bend radius of flexible tails50 mm
Cartridge nut tightening torque10 Nm
Optional aerator insert kit8 L/min, Part No. 20742

Frequently asked questions

What is the static inlet pressure range for the mixer?

The static inlet pressure range is 150-1000 kPa, and hot and cold water inlet pressures should be equal.

What is the maximum deck thickness and tap body hole size?

The deck can be a maximum of 45 mm thick and the tap body hole in the deck should be 34-36 mm.

What flow rate does the aerator insert give, and is a higher flow option available?

The mixer is fitted with a 5 L/min flow regulated aerator insert; an 8 L/min aerator insert kit (Part No. 20742) is available if required.

Can the mixer be used with a gravity feed system?

No, the document states the mixer is not suitable for gravity feed systems.

Download PDF (171 KB)