DONMAR M/C Heater with Waterproof Harness Installation Guide

Installation guide for the DONMAR M/C Heater with waterproof harness for motorcycle seat foam, covering placement, adhesive, wiring, switch and power.


DONMAR M/C Heater with Waterproof Harness Installation Guide - cover page
Brand
Donmar
Category
Vehicle Accessories
Document type
Installation Guide
Language
English
Pages
2
File format
PDF
File size
555 KB
Published
16 November, 2026
Updated
16 November, 2026
MD5 checksum
25D0F4CF1C675AB177149C7953F3329D

About this manual

The DONMAR M/C Heater with Waterproof Harness is a heating system designed to be installed on the foam surface of a motorcycle seat, under the seat cover. The available material is adhered to the seat and excess material is trimmed away.

The guide covers general installation advice, heater placement and adhesive steps, wiring and seat-cover reattachment, switch installation and connection, and switch operation. Installation must be performed by qualified personnel and the system must be connected to fused 12 volt accessory power.

What's inside

  • General Advice
  • Heater Installation
  • Switch Connection
  • Switch Operation

Specifications

Power supplyFused 12 volt accessory power
Continuous currentUp to 5 Amps
Switch hole size3/4 inch

Frequently asked questions

Where is the heater installed?

It is installed on the foam surface, under the seat cover.

How much current must the power system support?

It must be capable of driving up to 5 Amps continuous current.

What size hole is needed for the switch?

A 3/4 inch hole must be created for the switch.

Who should perform the installation?

Installation must be performed by qualified personnel only.

Download PDF (555 KB)