Installation instructions for the Domus Line APEX H7 LED profile, covering cut-out size, power connection, safety warnings and warranty.
This document provides multilingual installation instructions for the Domus Line APEX H7 LED profile. It describes making a 9x7 mm cut-out with a possible Ø8 mm cable hole, pressing the profile into the cut-out, and connecting the appliance to a 230/24 Vdc safety feeder; installation may require qualified personnel.
The safety notices state that the LED module is not replaceable and that the entire unit must be replaced if it fails. They also specify dry location and cabinet use only, a 24 Vdc Class 2 power supply, Type IC recessed installation, protection class III, and risk group 0 according to EN62471. Warranty terms are available at www.domusline.com. This manual is written in French.
| Cut-out dimensions | 9 x 7 mm |
|---|---|
| Cable hole diameter | Ø 8 mm |
| Power supply | 230/24 Vdc safety feeder |
| Operating voltage | 24 Vdc |
| Protection class | III |
| Photobiological risk group | 0 (FREE) according to EN62471 |
| Power supply class | Class 2 |
| Minimum distance from cabinet wall | 10 mm |
| Minimum compartment size | 300 mm x 300 mm |
The installation requires a 9 x 7 mm cut-out with a length suitable for inserting the APEX H7 profile; a Ø8 mm hole may also be made for the cable.
No, the LED module is not replaceable; if it fails, the entire unit must be replaced.
Connect the appliance to a 230/24 Vdc safety feeder, ensuring the APEX H7 rating does not exceed the feeder rating.
The general warranty terms and conditions are available at www.domusline.com.