Direction-Plus TC601DPK Isuzu D-Max Transmission Cooler Installation Guide

Installation guide for the Direction-Plus TC601DPK transmission cooler kit for 2012-2019 Isuzu D-Max 3.0L 4JJ1 diesel automatic.


Direction-Plus TC601DPK Isuzu D-Max Transmission Cooler Installation Guide - cover page
Brand
Direction Plus
Category
Vehicle maintenance
Document type
Installation Guide
Language
English
Pages
5
File format
PDF
File size
2.4 MB
Published
09 November, 2026
Updated
09 November, 2026
MD5 checksum
1B9CAFDEDB2B8D4B99B259111F4D1004

About this manual

This document is the installation guide for the Direction-Plus™ Isuzu D-Max Transmission Cooler Kit (TC601DPK), intended for a 2012-2019 Isuzu D-Max 3.0L 4JJ1 Diesel with automatic transmission. It lists the kit contents, required preparation, and step-by-step fitting instructions. The guide covers removing the front grille, mounting the cooler and brackets using original bolt locations, connecting the 950mm and 1100mm hoses to the cooler and stock transmission cooler, securing lines with clamps, cable ties and an insulated P Clip, and adding 265mL of factory specified ATF. It recommends installation by a competent qualified mechanic.

What's inside

  • Important before starting
  • Included in the kit
  • Oil cooler mounting location
  • Installation Guide
  • Transmission cooler assembly
  • Hose connections
  • Refilling transmission fluid
  • Reinstalling the grille

Specifications

Vehicle application2012-2019 Isuzu D-Max 3.0L 4JJ1 Diesel, automatic transmission
Cooler fluid capacity120mL
Hose fluid capacity145mL
Total ATF to add265mL
Hoses included950mm and 1100mm of 3/8" hose
Fasteners included8 x M6x16 bolts, 16 x M6 flat washers, 8 x M6 nyloc nuts

Frequently asked questions

Which vehicles does the TC601DPK transmission cooler kit fit?

It is for the 2012-2019 Isuzu D-Max 3.0L 4JJ1 Diesel with automatic transmission.

Is installing the Magnefine ATF filter required?

No, fitment of the Magnefine element is optional and can be installed in line at any point along the ATF hose, paying attention to the direction of flow.

How much transmission fluid must be added after installation?

265mL of factory specified ATF in total: 120mL for the cooler and 145mL for the hoses.

Who should carry out the installation?

It is recommended that the installation be carried out by a competent qualified mechanic.

Download PDF (2.4 MB)