Dell PowerVault NX3500 Systems Getting Started Guide covering rack installation, backup power supply battery setup, and system specifications.
The Dell PowerVault NX3500 Systems Getting Started With Your System guide explains unpacking the solution, installing the rails, system, and backup power supply in a rack. It then covers connecting the battery in the BPS power module, including removing the front cover and battery, rotating the battery 180°, reinserting it, and securing the cover.
The document also lists backup power supply environmental specifications and PowerVault NX3500 system technical specifications, such as processor, expansion slots, memory, physical dimensions, weight, and operating/storage conditions. Safety warnings note lethal voltages in the backup power supply and state that service must be performed by authorized service personnel only.
| Processor type | Intel Xeon processor 3400 series |
|---|---|
| Expansion slots | One x16 half-length slot and one x8 half-length slot |
| Memory architecture | 1333-MHz registered parity and unbuffered DDR-III memory modules |
| Memory module slots | Six 240-pin slots |
| Memory module capacity | 2 GB |
| Maximum RAM | 12 GB |
| Height | 4.29 cm (1.69 in) |
| Width | 43.4 cm (17.09 in) |
| Depth | 61.26 cm (24.12 in) |
| Maximum weight | 15 kg (33.02 lb) |
Connect the battery pack before connecting the power cable.
Rotate the battery 180° so the blind mate connector faces toward the back of the power module chassis.
The maximum RAM is 12 GB.
The 120 V model is Dell BPS 500 W (LV).