Dell update on AMD Opteron 24XX/84XX processors: HT Assist speeds HyperTransport transfers but reduces L3 cache from 6 MB to 5 MB; covers HT1/HT3 settings.
This Dell technical update from July 2009 covers AMD Opteron 24XX and 84XX processors equipped with the HT Assist feature. HT Assist allows faster HyperTransport (HT) transfers, but when enabled it reduces the L3 cache size from 6 MB to 5 MB. After the feature is enabled, the system reboots and reports the reduced L3 cache size, and it continues to do so until HT Assist is disabled. The feature can be turned on or off in the system BIOS settings.
The update also describes HyperTransport technology. Depending on system capability, the HyperTransport mode can be set to HT3; the system and/or processors may or may not be HT3 capable depending on when they shipped. At startup the system BIOS checks the system board revision number and the HT capability of all installed processors. If the system supports HT3 frequency, the HyperTransport Technology BIOS field defaults to HT3 and can be set to HT1 or HT3; if the system is not HT3 capable, the field is set to HT1 and is read-only.
| L3 cache size with HT Assist disabled | 6 MB |
|---|---|
| L3 cache size with HT Assist enabled | 5 MB |
| HyperTransport modes | HT1 or HT3 |
| HT3 technology availability | Selected Dell systems, early 2009 |
| HT3 processor availability | May 2009 |
When enabled, HT Assist reduces the L3 cache size from 6 MB to 5 MB. The system reports the reduced size after reboot and continues to do so until HT Assist is disabled.
Use your system's BIOS settings. For access instructions, see the Hardware Owner's Manual on the Dell Support website.
The HyperTransport Technology BIOS field can be set to HT1 or HT3, depending on which gives the best performance. On systems that are not HT3 capable, the field is set to HT1 and is read-only.
HT3 technology was added to selected Dell systems in early 2009, and HT3 processors became available in May 2009.