Dell PowerConnect M6220 Switch User Guide

User guide for the Dell PowerConnect M6220 switch covering hardware, cables and ports, system configuration, routing, IPv6, QoS and IP multicast.


Dell PowerConnect M6220 Switch User Guide - cover page
Brand
DELL
Category
Network Switches
Document type
User Manual
Language
Chinese
Pages
344
File format
PDF
File size
15.1 MB
Published
16 November, 2026
Updated
16 November, 2026
Model
M6220
MD5 checksum
9FD6BC4672CC3D082FE1574E8D359C88

About this manual

This is the user guide for the Dell PowerConnect M6220 switch, model M6220, revision A00 dated September 2007. It explains how to use and manage the switch through the Dell OpenManage Switch Administrator interface, and covers hardware description, cable and port information, and configuration of system information, switch information, link dependencies, statistics/RMON, routing, IPv6, quality of service and IP multicast.

The guide also describes the switch's physical interfaces, including 10/100/1000 Ethernet ports with RJ-45 connectors and dual 10G XAUI slots that support XFP modules at 10 Gbps or a stacking module at 12 Gbps. It includes instructions for serial cable connections to a terminal for initial setup, notes that the switch is powered from a Dell blade server chassis, and points to the CLI Reference Guide for related command information. This manual is written in Chinese.

What's inside

  • Introduction
  • Hardware Description
  • Using Dell OpenManage Switch Administrator
  • Cables and Port Information
  • Configuring System Information
  • Configuring Switch Information
  • Creating Link Dependencies
  • Viewing Statistics/RMON
  • Configuring Routing
  • Configuring IPv6

Specifications

Ethernet interfaces10/100/1000 Ethernet with RJ-45 connectors
Dual 10G slotsDual XAUI interfaces; 10 Gbps with XFP modules
Stacking speed12 Gbps with stacking module (left slot only)
Serial cableUSB Type A to female DB-9 null-modem cable
Power sourcePowered from the Dell blade server chassis
Time zone offset range-12 to +13 hours, 0-59 minutes

Frequently asked questions

How do I connect the M6220 to a terminal for initial setup?

Use the USB Type A to female DB-9 null-modem serial cable: connect it to the terminal's console ASCII DTE RS-232 port and to the switch's serial port, or to the master switch's serial port if configuring a stack.

How do I start a Telnet session on the M6220?

Open the Asset page and click Telnet; a prompt is then displayed indicating the system is ready to accept input. Appropriate Telnet parameters must be set beforehand.

What information does the Health page show?

It shows physical device information, including power supply status and the current operating temperature of the device.

Where does the PowerConnect M6220 get its power?

The switch draws power from the Dell blade server chassis; details are in the Dell Blade Server Chassis Hardware Owner's Manual.

Download PDF (15.1 MB)

More DELL Manuals


View all DELL manuals →