This guide provides initial setup and configuration instructions for the Dell DR4000 Systems E13S Series, including unpacking, rack installation, connecting…
The Dell DR4000 Systems E13S Series Getting Started Guide covers the initial installation and configuration of the system. It describes unpacking the system, assembling rails, installing the system in a rack, connecting optional keyboard, mouse, and monitor, connecting and securing power cables, turning on the system, and installing the optional bezel.
The document also provides operating system information, references to the Administrator’s Guide and Owner’s Manual for further setup and troubleshooting, and technical specifications such as dual Intel Xeon E5645 processors, up to 32 GB of DDR3 RDIMM memory, twelve 3.5-inch hot-swappable SAS drives, and various connectors including dual RJ-45 NICs, serial, USB, VGA, and iDRAC Enterprise port.
| Processor type | Two Intel Xeon processors E5645 series |
|---|---|
| Expansion Bus | PCI Express Generation 2 |
| Riser card expansion slots | Slot 1: PCIe x4, half-length, full-height; Slot 2: PCIe x4, full-length, full-height; Slot 3: PCIe x8, half-length, full-height; Slot 4: PCIe x4, internal slot for integrated storage card |
| Memory Architecture | 1333 MHz DDR3 RDIMMs |
| Memory module sockets | Eight 240-pin |
| Maximum RAM | 32 GB |
| Hard drives | Twelve 3.5" hot-swappable SAS or nearline-SAS drives and two cabled 2.5" SAS drives |
| Back NIC | Two RJ-45 (for integrated 1 GB NICs) |
| Serial | 9-pin, DTE, 16550-compatible |
| USB | Two 4-pin, USB 2.0-compliant |
| Video | 15-pin VGA |
| iDRAC Enterprise | One RJ-45 |
| Supply voltage | 100 V AC to 240 V AC |
| Frequency | 50/60 Hz |
| Current consumption | 7.5 A to 4.0 A |
The system supports a maximum of 32 GB of RAM.
The system uses two Intel Xeon processors from the E5645 series.
The system supports twelve 3.5-inch hot-swappable SAS or nearline-SAS drives and two cabled 2.5-inch SAS drives.
The system operates on 100 V AC to 240 V AC at 50/60 Hz.