Deck'Umbs Umbrella Holder Concrete Installation Guide

Deck'Umbs guide for installing its umbrella holder base in concrete: drilling, mortar fill, leveling, ring and holder installation, and removal.


Deck'Umbs Umbrella Holder Concrete Installation Guide - cover page
Brand
Deck'Umbs
Category
Outdoor Products
Document type
Installation Guide
Language
English
Pages
8
File format
PDF
File size
3.2 MB
Published
16 November, 2026
Updated
16 November, 2026
MD5 checksum
55DA9F52E5061D959B65076B5258ABF5

About this manual

This Deck'Umbs guide explains how to install a Deck'Umbs base and holder into an existing concrete surface so that an umbrella pole can be supported. It starts with the tools and hardware required — a 2-1/2" concrete drill, mortar (cement) mix and a small carpenter's level — and then walks through the steps in order.

The steps cover drilling and preparing the hole, attaching the plastic base setter and plastic plug to the base, positioning and leveling the base in two directions 90 degrees apart, pouring the mortar mix, and pressing the stainless steel Deck'Umbs ring into place. Later steps describe punching a drainage hole in the bottom plastic plug, locking the Deck'Umbs holder into the base, inserting the umbrella pole and tightening the knob, and finally removing the holder and covering the hole with the supplied plastic cap. Contact details for Deck'Umbs are given at the end.

What's inside

  • Tools & Hardware Required
  • Drilling the Hole in Concrete
  • Installing the Plastic Base Setter and Plug
  • Positioning and Leveling the Base
  • Pouring Mortar and Setting the Base
  • Removing the Setter and Pressing the Ring
  • Drainage Hole in the Plastic Plug
  • Inserting the Deck'Umbs Holder
  • Inserting the Umbrella Pole
  • Removal of the Holder

Specifications

Hole diameter2-1/2 in
Hole depth in existing concrete4-3/4 in
Mortar mix fill in holeAbout 1/3 of the hole depth
Clearance from concrete top surface to mortar surface3/4 in
Leveling checkTwo directions 90 degrees apart

Frequently asked questions

What tools and hardware are required for the concrete installation?

The guide lists a 2-1/2" concrete drill, mortar (cement) mix and a small carpenter's level.

How deep should the hole be drilled in the concrete?

Drill a 2-1/2" hole with a 4-3/4" depth in the existing concrete.

How much mortar mix goes into the hole?

Pour the mortar (cement) mix into the concrete hole to about 1/3rd of the hole depth.

How is the holder removed from the base?

Rotate the holder clockwise until it stops, then lift and rotate it counter-clockwise at the same time to disengage it from the base.

Download PDF (3.2 MB)