Daviteq MBRTU-SAL Salinity Sensor Modbus RTU Output User Manual

User manual for Daviteq MBRTU-SAL salinity sensor with Modbus RTU output, covering specs, wiring, maintenance, and protocol details.


Daviteq MBRTU-SAL Salinity Sensor Modbus RTU Output User Manual - cover page
Brand
daviteq
Document type
User Manual
Language
Chinese
Pages
13
File format
PDF
File size
430 KB
Published
16 November, 2026
Updated
16 November, 2026
MD5 checksum
28642DA6218AAF7FA05DDF8E4CB13FAB

About this manual

The Daviteq MBRTU-SAL is a salinity sensor using non-contact electromagnetic measurement. It features automatic temperature compensation via a built-in PT1000 sensor and is suitable for marine, industrial wastewater, pharmaceutical, and biotech applications. The sensor outputs Modbus RTU over RS-485 and includes calibration registers for temperature, zero point, and slope. Maintenance is minimal, with cleaning recommended every 30 days. The sensor is IP68 rated and can operate at depths up to 20 meters.

The manual details wiring, maintenance procedures, Modbus RTU protocol specifications (including baud rate, register addresses, and command examples), and calibration instructions for temperature and salinity. It also includes dimensions, contact information, and references to related documents. This manual is written in Chinese.

What's inside

  • Introduction
  • Specifications
  • Wiring
  • Maintenance and Precautions
  • Modbus RTU Protocol
  • Dimensions
  • Contact
  • Documents / Resources

Specifications

OutputRS-485, MODBUS/RTU
Measuring MethodNon contact electromagnetic principle
Range0 ~ 70PSU
Accuracy±1%F.S. or ±0.2PSU (Below 10psu)
Resolution0.1PSU
Working Environment0 ~ 65 ℃ ; < 0.6MPa
Calibration MethodTwo point calibration
Response Time10 seconds
Temperature CompensationAutomatic temperature compensation(PT1000)
Power Supply12-24VDC±10%, 10mA
SizeDiameter 30mm; Length 185.5mm; Protection level IP68; Water depth 20 meters
Service Life3 years or above

Frequently asked questions

What is the measurement range of the sensor?

The sensor measures salinity from 0 to 70 PSU.

How does the sensor compensate for temperature?

It uses a built-in PT1000 temperature sensor for automatic compensation.

What is the default baud rate for Modbus RTU?

The default baud rate is 9600 bps.

How often should the sensor be cleaned?

It is recommended to clean the sensor probe every 30 days.

Download PDF (430 KB)